Method of test for determination of fracture toughness in metallic materials using single edge notched tension (SENT) specimens
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2018. It was prepared by Subcommittee ISE/101/4, Toughness testing, under the authority of Technical Committee ISE/101, Test methods for metals. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This British Standard supersedes BS 8571:2014, which is withdrawn.
Information about this document: This standard has been developed primarily to meet the needs of the steel pipeline industry where this method has been used to determine the fracture toughness of girth welds experiencing plastic straining during installation. This is a full revision of the standard and introduces the following principal changes: consolidation of the clamped load J equations to give a single formula for all specimen dimensions; error in crack shape validity has been corrected; annexes have been added giving guidance on crack path deviation, and for testing of specimens with non-sharp notches; the example calculation has been revised and now covers calculation of CTOD and J; and the permitted range of a0/W has been narrowed. Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”). ii © THE BRITISH STANDARDS INSTITUTION 2018 – ALL RIGHTS RESERVED
Scope: This British Standard gives methods for determining fracture toughness in metallic materials in terms of δ (crack tip opening displacement, CTOD) and J (experimental equivalent of the J-integral) using single edge notched tension (SENT) specimens. This British Standard also gives a method for determining fracture toughness as a resistance to ductile crack extension (R-curve), or single point determination of fracture toughness at onset of unstable crack extension, or pop-in. The method uses specimens which have been notched and fatigue pre-cracked into parent metal, weld metal or heat affected zone (HAZ). The specimens are loaded in tension, and the force and crack mouth opening displacement are recorded. NOTE Methods to evaluate the suitability of a weld for notch placement within the target area and, where appropriate, to evaluate the effectiveness of the fatigue crack in sampling these areas are given in BS EN ISO 15653.