Guidance on investigations for ground gas. Permanent gases and Volatile Organic Compounds (VOCs)
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 April 2013. It was prepared by Technical Committee EH/4, Soil Quality. A list of organizations represented on this committee can be obtained on request to its secretary.
Information about this document: This standard is intended to be read in conjunction with BS 10175, Investigation of potentially contaminated sites – Code of practice. Test laboratory accreditation. Users of this British Standard are advised to consider the desirability of selecting test laboratories that are accredited to BS EN ISO/IEC 17025 by a national or international accreditation body.
Use of this document: As a guide, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification or a code of practice and claims of compliance cannot be made to it.
Presentational conventions: The guidance in this standard is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard provides guidance on the monitoring and sampling of ground gases. It covers volatile organic compounds (VOCs) and permanent gases such as carbon dioxide, methane and oxygen. It is intended to be read in conjunction with BS 10175. Guidance is not provided on: risk evaluation and characterization; NOTE 1 Guidance can be found in CLR 11 [3], CIRIA C665 [4], CIRIA C682 [5] and the Ground Gas Handbook [6]. selection and design of protective measures; the verification of protective measures, although the site investigation methodologies described can be used when appropriate; the sampling of atmospheric gases; monitoring and sampling for radon. NOTE 2 Radon occurs naturally at varying concentrations in large parts of the United Kingdom. It is commonly present in mine gas and can also be released from groundwater when it is extracted from the ground. It can also arise from deposited wastes such as those from the nuclear industry, phosphorus slags, and coal ash. Its importance lies in the fact that the risks associated with exposure to it are serious and its effects on the human condition are backed by extensive epidemiological information. There are established or draft International Standards for investigation and determination of radon in soils (BS ISO 18589 series) and in air (BS ISO 11665-1). The latter provides guidance on analysis of historic records, site reconnaissance, identification of preferential migration pathways, development of a sampling plan and how to measure radon in air once it has been emitted from the ground (see Annex B for further information). At the time of publication of this standard, the committee are not aware of any international standards or other authoritative guidance on the measurement and sampling of radon in the ground analogous to that provided in this standard for permanent gases and VOCs. The state-of-the-art is not sufficiently developed in the UK to provide such guidance as part of this standard but some preli
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Regulation of land contamination
- Annex B (informative) Radon
- Annex C (informative) Anaerobic degradation and the formation of methane
- Annex D (informative) Sources, properties and hazards of selected gases
- Annex E (informative) Sampling protocols – Permanent gases