BS 8586-2013+A1-2020 PDF

BS 8586-2013+A1-2020 PDF

Pin codes for BR 930 series relays. Specification

$220.98 $441.96 -50%
Publisher
isbn 9780539058543
Product Code: BS 8586
Stock In Stock
Published: 01/27/2020
Number of Pages: 208
File Size: 1 file, 13 MB

Available Options

Product Description

Pin codes for BR 930 series relays. Specification

Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2013. It was prepared by Subcommittee GEL/9/1, Railway Electrotechnical Applications – Signalling and communications, under the authority of Technical Committee GEL/9, Railway Electrotechnical Applications. A list of organizations represented on this committee can be obtained on request to its secretary.

Information about this document: If a previously unallocated pin code is to be used, details of the intended use that it can be authorized for inclusion in a future revision of this document. Details of any error or omission discovered in this standard need to be reported.

Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.

Scope: This British Standard specifies the pin code configurations and contact arrangements for signalling equipment that uses BR 829 [1] plugboards. The standard does not cover installation or maintenance requirements. Terms and definitions For the purposes of this British Standard, the following terms and definitions apply. 2.1 pin code unique numerical (or alphanumeric) reference allocated to a particular pin code configuration. NOTE The pin code is sometimes referred to as the 9registration pin code9. 2.2 pin code configuration unique pattern of locating pins assembled such that the item bearing this pattern of pins can only be connected to a corresponding item of equipment containing a matching unique pattern of holes BR 930 series pin code registration COMMENTARY ON CLAUSE 3 To ensure correct interchangeability of relays/units, an interlocking pin system is used which is designed to prevent a relay or unit being plugged-in to a fixed plugboard where it could give rise to an unsafe condition. Pins on the rear of the relay/unit locate in holes drilled in the BR 829 plugboard. Table 1, Table 2 and Table 3 list the applications to which pin code configurations have been allocated, and the configurations shall be used for no other application than that listed. Where a common chassis is provided for a number of potential applications, a separate pin code shall be allocated to each of those applications. The pin code only covers relay functionality and does not cover all the characteristics of the relay, such as coil resistance, which might vary. It is the responsibility of the end user to establish that the relay is appropriate for the particular application. NOTE 1 Table 1 lists the numerical codes and pin configurations and the relays and other applications to which they have been allocated for Great Britain (GB) mainline use. Configurations using five pins are allocated to safety critical applications and configurations with six pins to safety related applications. The

Contents:

  • Scope
  • Annexes
  • Annex A (informative) Arrangement of contacts and other connections
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 8586-2013+A1-2020 PDF

BS 8586-2013+A1-2020 PDF

$220.98 $441.96