Steels for the reinforcement of concrete. Reinforcement couplers. Requirements and test methods
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2015. It was prepared by Technical Committee ISE/104, Concrete reinforcing and pre-stressing steels. A list of organizations represented on this committee can be obtained on request to its secretary.
Information about this document: Product certification. Users of this British Standard are advised to consider the desirability of third-party certification of product conformity with this British Standard. Users seeking assistance in identifying appropriate conformity assessment bodies or schemes may ask BSI to forward their enquiries to the relevant association. Test laboratory accreditation. Users of this British Standard are advised to consider the desirability of selecting test laboratories that are accredited to BS EN ISO/IEC 17025 by a national or international accreditation body.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies requirements and test methods for steel reinforcement couplers (hereafter called couplers) to be used for the mechanical splicing of steel reinforcing bars. It specifies requirements for couplers to be used for mechanical splices in reinforced concrete structures under predominantly static loads and additional requirements for couplers to be used in elements of structures subject to high cycle elastic fatigue loading. It also specifies requirements for the evaluation of conformity of couplers. This British Standard does not specify requirements for couplers which are to be used for mechanical splices in reinforced concrete structures subject to low cycle loading in the elastic-plastic range. This British Standard specifies performance requirements for couplers. The couplers are tested as part of a mechanical splice between two lengths of reinforcing steel, manufactured in accordance with BS 4449 or BS 6744. The performance tests specified are therefore for mechanical splices incorporating the coupler being assessed. The requirements of this standard apply to the manufacture of couplers and not the assembly or installation of mechanical splices on site. NOTE Instructions for assembly or installation of couplers can be obtained from the manufacturer.
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Stainless steel couplers
- Annex B (informative) High cycle elastic fatigue testing
- Annex C (informative) Example of calculation of 99% and 95% characteristic
- Bibliography