Method for assessment of fire integrity of cast resin busbar trunking systems for the safety critical power distribution to life safety and fire fighting systems
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 April 2013. It was prepared by Technical Committee FSH/1, Fire safety cables. A list of organizations represented on this committee can be obtained on request to its secretary. Relationship with other publications The test method given in this British Standard is based on the furnace method for which general requirements are given in BS EN 1363-1.
Information about this document: The purpose of this test method is to measure the ability of a cast resin busbar trunking system to maintain circuit integrity to life safety and fire fighting systems when exposed to fire. The test method given in this British Standard has a test duration of 120 min which is considered to be the fire resistance period necessary for life safety and fire fighting applications when applied to busbar trunking distribution systems. It is emphasized that fire tests do not assess a fire hazard, nor can the results of fire tests alone guarantee safety. They only provide information to assist in the assessment of the suitability of a cast resin busbar trunking for a given application. Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage. The test given in this British Standard might involve the use of dangerous voltages and temperatures. Suitable precautions should be taken against the risk of shock, burning, fire and explosion that might be involved and against any noxious fumes that might be produced.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its methods are expressed as a set of instructions, a description, or in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard gives a method for assessment of the fire integrity of cast resin busbar trunking systems for the safety critical power distribution to life safety and fire fighting systems, intended to maintain circuit integrity when exposed to fire. It is applicable to cast resin busbar trunkings of rated voltage not exceeding 1 000 V a.c. NOTE Busbar trunking systems are specified in BS EN 61439-6:2012.
Contents: