BS 8701-2016 PDF

BS 8701-2016 PDF

Full ring ovalization test for determining the susceptibility to cracking of linepipe steels in sour service. Test method

$204.47 $408.94 -50%
Publisher
isbn 9780580894749
Product Code: BS 8701
Stock In Stock
Published: 06/30/2016
Number of Pages: 56
File Size: 1 file, 65 MB

Available Options

Product Description

Full ring ovalization test for determining the susceptibility to cracking of linepipe steels in sour service. Test method

Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 June 2016. It was prepared by Technical Committee PSE/17, Materials and equipment for petroleum, petrochemical and natural gas industries. A list of organizations represented on this committee can be obtained on request to its secretary.

Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.

Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its methods are expressed as a set of instructions, a description, or in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).

Scope: This British Standard gives a method for determining the susceptibility to cracking of steel pipes in sour service. This British Standard utilizes a tubular specimen comprising a full circumferential ring. The test method applies to any pipe with or without seam (longitudinal or spiral) or girth weld (with or without filler). NOTE 1 The specimen is usually a pipe but can also consist of flange neck or section of a bend, or other tubular component or a combination of the above. This British Standard provides guidance on determination of specimen size to ensure it retains residual stresses from manufacture and welding. NOTE 2 See Clause 7 for specimen sizes. The method utilizes ovalization to simulate hoop stress, using mechanical loading on a tubular form. The specimen is subjected to single sided exposure to the sour test environment. NOTE 3 The test also allows measurement of hydrogen permeation rates which can provide useful information, such as highlighting the effects of galvanic coupling between materials of apparent compatibility.

Contents:

  • Foreword
  • Introduction
  • Scope
  • Annexes
  • Annex A (normative) Ultrasonic examination of pipe, plate and welds during
  • Annex B (normative) Ring loading
  • Annex C (informative) Typical internal and external load application rigs for use
  • Annex D (normative) Chemistry of test solutions
  • Annex E (informative) Analysis of test solution – iodimetric titration
  • Annex F (informative) Illustrated summary of the full ring test procedure
  • Annex G (informative) Hydrogen sulfide (H2S) health and safety
  • Annex H (informative) Sample identification and test record, Form 1
  • Annex I (informative) Sample identification and test record, Form 2
  • Annex J (informative) Acceptance criteria
  • Annex K (informative) Sulfide stress corrosion (SSC) and hydrogen induced
  • Annex L (informative) Explanatory notes on test method: Galvanic Coupling
  • Annex M (informative) Modified test procedure for externally loaded test
  • Annex N (informative) Magnetic particular inspection (MPI) procedure
  • Bibliography

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 8701-2016 PDF

BS 8701-2016 PDF

$204.47 $408.94