Plastics. Joining of thermoplastic moulded components. Specification of variables for thermal joining processes
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 January 2018. It was prepared by Technical Committee WEE/3, Welding of Thermoplastic Moulded Components. A list of organizations represented on this committee can be obtained on request to its secretary.
Information about this document: This British Standard has been developed to help organizations better understand and implement controls with the following thermal joining processes through the use of thermal joining process specifications: ultrasonic welding/staking/spot welding; infrared welding; hot gas convection welding; linear vibration welding; orbital vibration welding; spin welding; laser welding; hot plate welding; heat staking: hot air; heat staking: electrical; and heat staking: infrared (IR).
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard specifies the minimum essential variables in order to produce a component of the required consistency and quality for the following thermal joining processes: ultrasonic welding/staking/spot welding; infrared welding; hot gas convection welding; linear vibration welding; orbital vibration welding; spin welding; laser welding; hot plate welding; heat staking: hot air; heat staking: electrical; and heat staking: infrared (IR). This British Standard defines the thermal joining process specification (TJPS) for each of the thermal joining processes listed above, to ensure that all the essential variables are properly considered, including the qualified range of each variable, in order to establish and maintain component quality at an acceptable level.