BS +AU 148-12-1969 PDF

BS +AU 148-12-1969 PDF

Methods of test for motor vehicle paints-Resistance to accelerated weathering

$90.17 $180.34 -50%
Publisher
isbn 0580053288
Product Code: BS +AU 148-12
Stock In Stock
Published: 03/31/1969
Number of Pages: 14
File Size: 1 file, 560 KB

Available Options

Product Description

Methods of test for motor vehicle paints-Resistance to accelerated weathering

Scope: This Part of this British Standard describes methods of carrying out accelerated weathering tests on motor vehicle paints and illustrates the apparatus required to perform them. 2 Test procedures NOTE It is recognized that the following test procedures may not be entirely suitable for the evaluation of new paint formulations which have recently become generally available. This matter is under investigation which may lead, subsequently, to the issue of amendment or extension of this standard. 2.1 Panels 150 mm × 100 mm, or other convenient size, specified and pretreated in accordance with the requirements of BS 3900, Part A32) (note particularly Clause 2.2) shall be coated in accordance with the requirements of BS 3900, Part A42), with the paint system to be tested. Panels shall be aged, under normal laboratory conditions, for 7 days before testing, unless otherwise agreed. 2.2 Test No. 1 2.2.1 Equipment. The apparatus consists essentially of a water-cooled central vertical mercury arc of source of ultraviolet3) around which rotates a test panel carrier, at a radial distance of 610 mm. One rotation is completed every 86 s. Surrounding the arc tube at its upper and lower extremities and facing the test panels are two banks of 240 V infrared lamps which are controlled at a black body temperature of 74 °C. A jet of demineralized water at 25 ± 1 °C sprays the test panels at the rate of 90 l/h, for a traverse distance one panel width. The whole apparatus is shrouded in a metal casing, in order to prevent the egress of ultraviolet light and hot air. The principal features of the equipment are shown in Figure 1 to Figure 4. 2.2.2 Method. Panels are exposed to 3 successive cycles, each consisting of: 1) 4 h infrared, plus ultraviolet emission, plus water spray. 2) 1 h water spray only. 3) 4 h infrared, plus ultraviolet emission, plus water spray. Total test time = 27 h. 2.2.3 Environmental control. It is important that the following environmental limits are maintained: 1) Ul

Contents:

  • Foreword
  • Introduction
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS +AU 148-12-1969 PDF

BS +AU 148-12-1969 PDF

$90.17 $180.34