BS +AU 148-4-1969 PDF

BS +AU 148-4-1969 PDF

Methods of test for motor vehicle paints-Resistance to abrasion

$90.17 $180.34 -50%
Publisher
isbn 0580059707
Product Code: BS +AU 148-4
Stock In Stock
Published: 07/31/1969
Number of Pages: 8
File Size: 1 file, 260 KB

Available Options

Product Description

Methods of test for motor vehicle paints-Resistance to abrasion

Scope: This Part of this British Standard describes a method of test to be used for the evaluation of the resistance of a paint film to abrasion or wear which may occur in service, e.g. by handling of component parts such as levers and knobs. 2 Test panels 2.1 Panels of convenient size, specified and pretreated in accordance with the requirements of BS 3900-A32) (note particularly Clause 2.2) shall be coated in accordance with the requirements of BS 3900-A42) with the paint system to be tested. Steel panels are often used but it may be appropriate to use other substrates, e.g. plastics. 2.2 In general it will be found most convenient to use panels 100 mm × 100 mm and not more than 3 mm thick, with a 6 mm diameter hole in the centre to allow fixing in the apparatus. Some available instruments have accessories which permit the use of panels up to 12 mm thick and these usually require a 9 mm diameter fixing hole. If desired panels may have the corners cut off or rounded. 2.3 Panels shall be aged, under normal laboratory conditions, for 7 days before testing, unless otherwise agreed. 3 Apparatus 3.1 The apparatus shall be a rotary platform double head abrasion tester with associated equipment. NOTE The apparatus described below is similar to the unit described in ASTM Standard D1175 – 64T, “Abrasion resistance”. 3.2 The apparatus comprises: 1) A circular rotating platform on which shall be mounted the test panel. 2) A revolution counter for 1) above. 3) A pair of pivoted arms to which shall be attached abrasive wheels. 4) An electric motor and cooling fan. 5) Housing for the sub-assemblies referred to in 1), 2) and 4) and forming a base for mounting the pivoted arms with abrasive wheels as outlined in 3). 6) Controls. 3.3 Rotating platform. The rotating platform is approximately 100 mm (4 in) diameter mounted on a vertical spindle driven by an electric motor. The vertical spindle projects above the platform surface and is provided with a knurled clamping nut so that the test p

Contents:

  • Foreword
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS +AU 148-4-1969 PDF

BS +AU 148-4-1969 PDF

$90.17 $180.34