Scope: This Part of this British Standard describes a method for the hardness testing of paints for motor vehicles using the following methods: 1) Pencil method. 2) Persoz pendulum method. 3) Wallace micro-hardness method. 4) Pyramid micro-hardness method. Tables for obtaining hardness numbers from ocular readings in the Diamond pyramid test are given. 2 Test panels 2.1 Test panels, when used, shall be 150 mm × 100 mm or other convenient size, specified and pretreated in accordance with the requirements of BS 3900-A32) (note particularly Clause 2.2) and shall be coated, in accordance with the requirements of BS 3900-A42), with the paint system to be tested. Normally steel panels are used. 2.2 Particular care shall be taken to ensure that the panels are flat and that the paint film is substantially free from blemishes such as ridges, brush marks and “orange-peel” effect. The panels shall be aged, under normal laboratory conditions, for 7 days unless otherwise agreed. Test panels are not normally used for the “pencil” method which is primarily intended for use in the production shop. 3 Pencil method A range from 2B to 6H of high quality drawing pencils, such as the makes specified below3), or their equivalent, is required. The pencils shall be sharpened to a point with a pencil sharpener. The softest pencil shall be held normal to the paint film to be tested and pressed sufficiently to make the point crumble. Without altering the pressure, the pencil is drawn across the paint film for a distance of 6 mm. This procedure shall be repeated with pencils of higher grades of hardness until the paint film is scratched or penetrated. The grade of hardness of the pencil used immediately before that which caused scratching or penetration shall be taken as the hardness of the paint film. The figures of 3 determinations shall be recorded. 4 Persoz pendulum method 4.1 The pendulum, which is supported on the test panel with the steel balls resting on the surface under test, is made to swi