BS +AU 165A-1990 PDF

BS +AU 165A-1990 PDF

Specification for performance requirements for original equipment jacks for passenger cars and light vans

$90.17 $180.34 -50%
Publisher
isbn 0580186385
Product Code: BS +AU 165A
Stock In Stock
Published: 07/31/1990
Number of Pages: 10
File Size: 1 file, 280 KB

Available Options

Product Description

Specification for performance requirements for original equipment jacks for passenger cars and light vans

Scope: This British Standard specifies requirements for the materials, finish and safe performance of jacks supplied as original equipment with passenger cars of the European Communities classification category M1 and light vans of the European Communities classification N1 (see Appendix A). 2 General 2.1 The jack shall be suitable for locating at the jacking points as specified by the vehicle manufacturer and shall be capable of being operated without fouling any part of the vehicle with the doors closed. 2.2 It shall not be possible to raise the vehicle with a jack that has been incorrectly assembled from its component parts. 2.3 Means shall be provided to prevent over-travel of the jack. 2.4 Instructions for the safe use of the jack shall be provided. 2.5 Written instructions for the use of the jack shall be provided in the vehicle manufacturer’s instruction manual, together with the following information. NOTE It may be in a style compatible with the remainder of the vehicle manual text. a) The vehicle jack is only for wheel changing and snow chain attachment (if appropriate). b) Do not place any part of the body under the vehicle when the vehicle is supported by the jack alone. Note that it is very dangerous for users to go underneath a vehicle supported only by the vehicle jack. For repair work where the user needs to go underneath, special vehicle supports are to be used. c) Use chocks when stopped on a hill or cambered road. Seek advice on the number, position and placement of chocks from the manufacturer’s handbook. Note that the jack is designed only for use on a gradient of less than 8 % and a camber of less than 5.5 %. d) When using the vehicle jack for wheel changing at the roadside: 1) use hazard lights; 2) apply the handbrake; 3) place gears in “1” or “Reverse” on manual gear boxes, or “P” on automatic transmissions; 4) occupants should leave the vehicle; 5) place the jack at the placement position advised by the vehicle manufacturer; 6) give consideration t

Contents:

  • Foreword
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS +AU 165A-1990 PDF

BS +AU 165A-1990 PDF

$90.17 $180.34