Insulator and conductor fittings for overhead power lines-Performance and general requirements
Publishing information: This part of BS 3288 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2014. It was prepared by Technical Committee PEL/11, Overhead lines. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This part of BS 3288 supersedes BS 3288-1:1997, which is withdrawn.
Information about this document: BS 3288 applies primarily to fittings for overhead electric power lines. The various parts of BS 3288 specify the performance, general requirements and dimensional requirements for insulator and conductor fittings. The general and dimensional requirements may be applied to similar fittings used on overhead railway electrification systems and in substations. This British Standard is not applicable to fittings exclusively intended for use on aerial bundled conductor systems or to low voltage connectors. BS 3288-1 is part of a series that contains the following current parts: Part 2: Specification for a range of fittings; Part 3: Dimensions of ball and socket couplings of string insulator units. The original suite of standards also contained BS 3288-4 but this has been superseded by BS EN 60372.
Use of this document: It has been assumed in the preparation of this part of BS 3288 that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies performance and general requirements for insulator and conductor fittings for use on overhead power lines. It defines the relevant tests and test procedures together with the acceptance criteria. The tests and test procedures may also be applied to similar fittings, outside the scope of this standard, intended for use in: the overhead equipment of electric traction lines; substations.
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Diagrammatic representation of electrical type test
- Annex B (normative) Mathematical acceptance criterion
- Annex C (informative) Information to be supplied by the purchaser
- Bibliography