Manufacture of saddle trees made from wood. Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 June 2015. It was prepared by Subcommittee SW/136/14, Saddle trees, under the authority of Technical Committee SW/136, Sports, playground and other recreational equipment. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 6635:2003, which is withdrawn.
Information about this document: This is a full revision of the standard, and introduces the following principal changes to the specified: quality of component metals; quantity, type and dimensions of rivets; manufacturing process; and load test failure value.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies constructional and dimensional requirements for the manufacture of saddle trees made from wood. It applies to horse-riding saddles for general use (jumping, showing, hacking, dressage and similar activities) but excludes saddle trees for use with racing saddles. This standard does not give requirements for saddle trees made from synthetic materials, which are given in BS 7875.
Contents:
- Foreword
- Scope
- Bibliography