Flexible hoses, end fittings and sockets for gas burning appliances-Strip-wound metallic flexible hoses, covers, end fittings and sockets for domestic appliances burning 1st, 2nd and 3rd family gases. Specification
Publishing information: This part of BS 669 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 January 2022. It was prepared by Technical Committee GSE/42, Gas fittings and connections. A list of organizations represented on this committee can be obtained on request to the committee manager. Supersession This part of BS 669 supersedes BS 669‑1:1989, which is withdrawn. Relationship with other publications BS 669 is published in the following parts: Part 1: Strip-wound metallic flexible hoses, covers, end fittings and sockets for domestic appliances burning 1st, 2nd and 3rd family gases – Specification; and Part 2: Specification for corrugated metallic flexible hoses, covers, end fittings and sockets for catering appliances burning 1st, 2nd and 3rd family gases.
Information about this document: This is a full revision of the standard, and introduces the following principal changes: technical content revised and standards updated to current editions; classification of products based on reaction to fire added; and addition of 3rd family gases. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This part of BS 669 specifies requirements for strip-wound flexible hoses, and end fittings and sockets for use with domestic appliances (including cookers). It applies to hoses designed for use with 1st and 2nd family gases at a nominal inlet pressure not exceeding 20 mbar1) or for 1st, 2nd and 3rd family gases at a nominal inlet pressure not exceeding 50 mbar. The requirements for strip-wound flexible hoses with end fittings attached are specified in Section 2. Section 3 specifies additional requirements for the end fittings and sockets. NOTE Strip-wound flexible connection assemblies in accordance with this specification are not suitable for installations where the ambient air temperature exceeds 70 °C, nor where there is the possibility of contact with hot surfaces exceeding 95 °C.