BS 7891-1997 PDF

BS 7891-1997 PDF

Determination of resistance against autoclaving, corrosion and thermal exposure for surgical and dental hand instruments

$80.01 $160.02 -50%
Publisher
isbn 058026646X
Product Code: BS 7891
Stock In Stock
Published: 03/15/1997
Number of Pages: 10
File Size: 1 file, 270 KB

Available Options

Product Description

Determination of resistance against autoclaving, corrosion and thermal exposure for surgical and dental hand instruments

Scope: This International Standard describes test methods to determine the resistance of stainless steel surgical and dental hand instruments against autoclaving, corrosion and thermal exposure. The requirements for such tests are defined and stated in the product standard along with the number of cycles for each test procedure. Other, additional, tests may also be required (see the Introduction). 2 Normative reference The following standard contains provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 3696:1987, Water for analytical laboratory use — Specification and test methods. 3 Autoclave test for corrosion The autoclave test attempts to simulate the service environment; it is therefore based on recommended methods of sterilization. 3.1 Reagent The water used for the test shall be of quality 3 in accordance with ISO 3696:1987. 3.2 Apparatus Autoclave, operating in the non-vacuum mode, capable of being operated at 134 ░C to 138 ░C and 0,22 MN╖m–2. 3.3 Preparation Scrub the instrument using soap and warm water. Rinse thoroughly in water (3.1) and dry. 3.4 Test procedure Place the instrument, unwrapped on a tray, into the autoclave. Using the water (3.1) subject the instrument to an autoclaving cycle of ( ) min at 134 ░C to 138 ░C and 0,22 MN╖m–2. After the cycle, open the door. Remove the tray and allow the contents to cool to room temperature. 3.5 Evaluation Refer to the appropriate product standard for specific requirements. 4 Boiling water test for corrosion The boiling water test is specified for determining corrosion resistance. 4.1 Reagent The water use

Contents:

  • Introduction
  • Scope
  • Annex A (informative) Rationale

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 7891-1997 PDF

BS 7891-1997 PDF

$80.01 $160.02