Guide to the selection, installation, operation and calibration of diagonal path transit time ultrasonic flowmeters for industrial gas applications
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 October 2013. It was prepared by Subcommittee CPI/30/5, Velocity based methods, under the authority of Technical Committee CPI/30, Measurement of fluid flow in closed conduits. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 7965:2009, which is withdrawn.
Information about this document: This is a full revision of the standard, and introduces the following principal changes: further division of meter sizes into large, medium and small to incorporate meter sizes with a nominal bore <4 inches; meters that are not standard in line meters, such as cartridge type meters; where appropriate, the standard is aligned with revisions made to other USM documents such as AGA Report No. 9 [1] and BS ISO 17089-1, taking account of results from research and development projects and end-user experience; updated in the light of research and user experience since 2009; includes a new section covering condition-based maintenance. Hazard warnings CAUTION: High gas velocities can cause flow-induced thermowell vibration, which could result in catastrophic metal fatigue failure of the thermowell. CAUTION: The use of extractor tools to extract ultrasonic transducers without depressurization should only be undertaken by competent personnel.
Use of this document: As a guide, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification or a code of practice and claims of compliance cannot be made to it.
Presentational conventions: The guidance in this standard is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard gives recommendations and guidance on the selection, installation, operation and calibration of transit time ultrasonic flowmeters (USMs) for industrial gas applications (including flare gas). It is applicable only to those devices in which the entire gas stream flows through the body of the USM and the transducers (wetted or invasive type), or a wetted interface, are in contact with the fluid. This includes full-bore/reduced-bore and insertion type meters employing direct or reflective paths. It is also applicable to “dirty gases”, i.e. those contaminated with solids and/or liquids in sufficiently small quantities, depending upon the application. It is not applicable to clamp-on/externally mounted, domestic or stack/chimney (combustion exhaust) meters. As an aid to selection, this standard incorporates an uncertainty classification for USMs. This takes into account the components of uncertainty relating to the meter plus those additional uncertainties associated with installation and operation effects. There are four classifications offered. These range from high accuracy applications (Class 1) to process flow indication and control applications (Class 4).
Contents:
- Foreword
- Scope
- Annexes
- Annex A (informative) Application of flow calibration results
- Annex B (informative) Methods for correcting a USM’s flow measurement error
- Annex C (informative) Thermowell installations in bi-directional flow
- Bibliography