Specification for limestone fines for use with Portland cement
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 January 2016. It was prepared by Subcommittee B/516/6, Cement specifications, under the authority of Technical Committee B/516, Cement and lime. A list of organizations represented on these committees can be obtained on request to its secretary. Supersession This British Standard supersedes BS 7979:2001, which is withdrawn.
Information about this document: This new edition of BS 7979 incorporates technical changes only. It does not represent a full review or revision of the standard, which will be undertaken in due course.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as:‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies requirements for the production, chemical composition and mechanical and physical properties of limestone fines for use in combination with CEM I Portland cement strength class 42.5 or higher conforming to BS EN 197-1 as a component of concrete, mortar or grout. It also specifies requirements for marking, provision of information, sampling and testing for acceptance at delivery, and conformity criteria for the manufacturer’s autocontrol system. Guidance on the use of limestone fines is given in Annex A.
Contents:
- Scope
- Annexes
- Annex A (informative) Product guidance
- Annex B (normative) Conformity assessment
- Annex C (normative) Method of determining the moisture content
- Bibliography