Safety nets on construction sites and other works. Code of practice
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 October 2019. It was prepared by Subcommittee B/514/27, Nets and sheets, under the authority of Technical Committee B/514, Access and support equipment. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS 8411:2007, which is withdrawn. Relationship with other publications This British Standard gives recommendations on how safety nets manufactured to conform to BS EN 1263‑1:2014 and installed as specified in BS EN 1263‑2:2014 can be used to enhance safety for those working at height.
Information about this document: This is a full revision of the standard, and introduces the following principal changes: removal of additional half metre safety zone; removal of the technique of pinning as no longer used; clarification of temporary repairs; clarification relating to rigging nets as close as possible to working level; and clarification on working practices in eaves bags. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed.
Use of this document: As a code of practice, this British Standard takes the form of guidance and recommendations. It should not be quoted as if it were a specification and particular care should be taken to ensure that claims of compliance are not misleading. Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. ii © THE BRITISH STANDARDS INSTITUTION 2019 – ALL RIGHTS RESERVED The word “should” is used to express recommendations of this standard. The word “may” is used in the text to express permissibility, e.g. as an alternative to the primary recommendation of the clause. The word “can” is used to express possibility, e.g. a consequence of an action or an event. Notes and commentaries are provided throughout the text of this standard. Notes give references and additional information that are important but do not form part of the recommendations. Commentaries give background information. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard provides recommendations on the safe use, installation and effective maintenance of safety nets on construction sites and other works where there is a risk of fall. It is intended for use by designers, engineers, safety net installers, end users and authorities having jurisdiction, for example the Health and Safety Executive (HSE). It is applicable to safety nets that conform to BS EN 1263‑1:2014 and that are installed within the positioning limits given in BS EN 1263‑2:2014. However, as these standards give specific minimum size limits, this British Standard also gives guidance on how to assess the reliability of safety nets outside these limits. NOTE Advice is given in Annex A. This British Standard covers safety net systems “S”, “T” and “U” as given in BS EN 1263‑2:2014, Clause 5, Clause 6 and Clause 7 respectively. It does not cover system “V” (Clause 8). This British Standard does not cover tensioned access platform nets, which are intended for persons to stand on either for access, egress or work.