Specification for subsoil and requirements for use
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2013. It was prepared by Technical Committee AW/20, Topsoil, other growing media and turf. A list of organizations represented on this committee can be obtained on request to its secretary. Relationship with other publications This British Standard is intended to complement BS 3882 which specifies topsoil.
Information about this document: Test laboratory accreditation. Users of this British Standard are advised to consider the desirability of selecting test laboratories that are accredited to BS EN ISO/IEC 17025 by a national or international accreditation body.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced. Hazard warnings WARNING. This British Standard calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Requirements in this standard are drafted in accordance with the Rules for the structure and drafting of UK standards, subclause J.1.1, which states, “Requirements should be expressed using wording such as: ‘When tested as described in Annex A, the product shall ...’”. This means that only those products that are capable of passing the specified test will be deemed to conform to this standard.
Scope: This British Standard specifies requirements for the classification, composition and use of subsoils that are moved or traded for creating soil profiles intended to support plant growth. The standard is not applicable to topsoil, or to subsoil that is to remain in situ. It is not intended to preclude the use of subsoil that is already on site and suitable for its intended purpose. This standard specifies requirements for multipurpose subsoil, which is fit for the majority of needs, and also specific purpose subsoils that are acidic or calcareous, for specialist use where acidic or calcareous soil profiles are required. It also specifies requirements for sampling and analysis of subsoil.
Contents:
- Foreword
- Introduction
- Scope
- Annexes
- Annex A (normative) Method of sample reduction and preparation
- Annex B (normative) Determination of mass loss on ignition
- Annex C (normative) Determination of mineral carbonate content of soil (as
- Annex D (normative) Extraction of the exchangeable cations in soil for
- Annex E (normative) Calculation of exchangeable sodium percentage of soil
- Annex F (normative) Determination of the specific electrical conductivity of a
- Annex G (normative) Method for determining other contaminants
- Annex H (normative) Importance of soil electrical conductivity, soil salinity and
- Bibliography