External timber cladding-Method of specifying
Publishing information: This part of BS 8605 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 December 2014. It was prepared by Panel B/543/-/2, External timber cladding, under the authority of Technical Committee B/543, Round and sawn timber. A list of organizations represented on this committee can be obtained on request to its secretary. Relationship with other publications Part 1: Method of specifying; and Part 2: Code of practice for design and installation. Some types of external timber cladding are covered by harmonized European Standards BS EN 14915 or BS EN 13986. This British Standard offers suppliers and designers additional information relevant to the UK’s climate and construction practices.
Use of this document: It has been assumed in the preparation of this part of BS 8605 that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This part of BS 8605 describes methods of specifying the characteristics of external timber cladding products from which selection has to be made and for which values might have to be agreed between the purchaser and manufacturer. This part of BS 8605 complements harmonized standards BS EN 14915 and BS EN 13986. It lists all performance requirements that might apply to external timber cladding in the UK and provides a method of specifying those requirements that are outside the scope of those standards, but which are relevant to the UK’s climate and construction practices. This part of BS 8605 specifies characteristics of components at the time they are transferred to the purchaser. It is intended for use by specifiers of external timber cladding components.
Contents:
- Foreword
- Introduction
- Scope
- Annexes
- Annex A (informative) CE marking of external timber cladding
- Annex B (normative) Sampling of boards
- Annex C (informative) Characteristics of timber species
- Annex D (informative) Timber durability selection
- Annex E (normative) Timber grading for boards
- Annex F (informative) Geometrical characteristics of boards
- Annex G (informative) Reaction to fire
- Bibliography