Personal fall protection equipment. Anchor systems. Specification
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2017. It was prepared by Technical Committee PH/5, Personal Fall Protection. A list of organizations represented on this committee can be obtained on request to its secretary. Product certification/inspection/testing Users of this British Standard are advised to consider the desirability of third-party testing of product conformity with this British Standard. Appropriate conformity attestation arrangements are described in Annex A. Users seeking assistance in identifying appropriate conformity assessment bodies or schemes may ask BSI to forward their enquiries to the relevant association.
Use of this document: Any user claiming compliance with this British Standard is expected to be able to justify any course of action that deviates from its recommendations. Users of this British Standard are expected to be able to demonstrate compliance with all applicable requirements.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in italic type, and does not constitute a normative element.
Scope: This British Standard provides requirements and test methods for type testing anchor systems that are installed and tested in the base materials specified by the manufacturer for: a) restraint systems; b) fall arrest systems; c) rope access systems; d) work positioning systems; e) rescue systems; and f) evacuation systems. This British Standard covers anchor systems intended for one or more users simultaneously and specifies the maximum number of users for each type of anchor system. NOTE 1 Where the manufacturer intends to rate their anchor systems for more than the specified maximum number of users, it is recommended that they liaise with an appropriate test house, taking into account the principles of this British Standard and develop a test specification accordingly. This British Standard is not applicable to: 1) equipment conforming to BS EN 516 or BS EN 517; 2) type A load-limiting anchor systems (see 3.3.2) for: rope access and work positioning; BRITISH STANDARD rescue – accompanied descent; rescue – remotely operated – redirect attachment; and evacuation, as they are considered not to be appropriate for such use. 3) type C non-load-limiting and load-limiting anchor systems (see 3.3.3) for: rope access and work positioning; rescue – accompanied descent; rescue – remotely operated – redirect attachment; and evacuation, as they are considered not to be appropriate for such use. 4) type B and type E, as described in BS EN 795, are not covered in this British Standard as they are not installed in a base material; 5) bespoke structurally designed anchors incorporated into structures. NOTE 2 The performance requirements in this British Standard are intended as minimum requirements for anchor devices, structural anchors and their base material(s). The performance requirements do not constitute structural verification of the structures for the imposed loads. This British Standard is intended for use by manufacturers, installers and users of anchor systems and also o