Water meters. Additional requirements for meters with polymer main casings
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2017. It was prepared by Subcommittee CPI/30/7, Volume flow-rate methods, under the authority of Technical Committee CPI/30, Measurement of fluid flow in closed conduits. A list of organizations represented on this committee can be obtained on request to its secretary.
Information about this document: With the increased importance of product environmental life cycle analysis, the move to reduce sources of lead in water networks and cost reduction initiatives, water meters are increasingly being specified with a polymer main casing, particularly for domestic applications. The current standards for water meters, BS EN ISO 4064 (all parts) and OIML R49 2013, were developed prior to the extensive conversion to polymer main casings and therefore contain no specific requirements for these. Polymer main casings do not display the same mechanical properties as more traditionally used brass alloys and many formulations, compounds and grades are available. This standard is intended to complement BS EN ISO 4064 (all parts) by offering additional technical specifications and type approval procedures for meters with polymer main casings.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of The Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”).
Scope: This British Standard specifies additional requirements for water meters with polymer main casings used to meter the actual volume of clean, cold potable water or heated water flowing through a fully charged, closed conduit which are not already described in BS EN ISO 4064 (all parts). It applies to meters where the main casing of the meter, which is subject to the water pressure, is manufactured from a polymer material and where the strength of the casing to withstand that water pressure is reliant on the strength of the polymer. It does not include the use of polymer coatings on the wetted surfaces of metal main casings, where the coating is not considered structural.