BS 903-A9-2020 PDF

BS 903-A9-2020 PDF

Methods of testing vulcanized rubber-Determination of abrasion resistance. Akron and Taber methods

$105.41 $210.82 -50%
Publisher
isbn 9780539122930
Product Code: BS 903-A9
Stock In Stock
Published: 11/24/2020
Number of Pages: 20
File Size: 1 file, 790 KB

Available Options

Product Description

Methods of testing vulcanized rubber-Determination of abrasion resistance. Akron and Taber methods

Publishing information: This part of BS 903 is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 30 November 2020. It was prepared by Technical Committee PRI/22, Testing and analysis of rubber. A list of organizations represented on this committee can be obtained on request to the committee manager. Supersession This part of BS 903 supersedes BS 903‑A9:1988, which is withdrawn.

Information about this document: This is a full revision of the standard, and introduces the following principal changes. The number of methods described has been reduced from four to two: the rotating cylindrical drum method and the Du Pont method have been removed. The standard rubber for use with the rotating cylindrical drum method has been removed. Reference is made to BS ISO 23794 for comparison of methods. This publication can be withdrawn, revised, partially superseded or superseded. Information regarding the status of this publication can be found in the Standards Catalogue on the BSI website at bsigroup.com/standards, or by contacting the Customer Services team. Where websites and webpages have been cited, they are provided for ease of reference and are correct at the time of publication. The location of a webpage or website, or its contents, cannot be guaranteed. Hazard warnings WARNING. This part of BS 903 calls for the use of substances and/or procedures that can be injurious to health if adequate precautions are not taken. It refers only to technical suitability and does not absolve the user from legal obligations relating to health and safety at any stage.

Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.

Presentational conventions: The provisions of this document are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. Where words have alternative spellings, the preferred spelling of the Shorter Oxford English Dictionary is used (e.g. “organization” rather than “organisation”). ii © THE BRITISH STANDARDS INSTITUTION 2020 – ALL RIGHTS RESERVED

Scope: This part of BS 903 describes two methods (Method A: Akron method and Method B: Taber method) for determining the abrasion resistance of rubber by comparing the wear of the rubber under test with that of a standard rubber under the same conditions.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 903-A9-2020 PDF

BS 903-A9-2020 PDF

$105.41 $210.82