BS 903-C4-1983 PDF

BS 903-C4-1983 PDF

Physical testing of rubber-Determination of electric strength

$52.07 $104.14 -50%
Publisher
isbn 0580133176
Product Code: BS 903-C4
Stock In Stock
Published: 09/30/1983
Number of Pages: 16
File Size: 1 file, 500 KB

Available Options

Product Description

Physical testing of rubber-Determination of electric strength

Scope: This Part of this British Standard gives two methods of determining the short-time electric strength (breakdown voltage) of insulating vulcanized rubber (including ebonite) and of solid plastics materials using a voltage with a nominal frequency of 50 Hz. One method of determining electric strength is by rapidly increasing the voltage until breakdown occurs and the other is by a steady increase in the applied voltage step-by-step at 20 s intervals. Test pieces and electrode systems are specified to provide tests on a variety of materials and forms of material. Tests are carried out normal and parallel to the planes of sheet materials and tubes and parallel to the axes of rods. NOTE The titles of the publications referred to in this standard are listed on the inside back cover. 2 Definitions For the purposes of this British Standard, the following definitions apply. 2.1 voltage the peak value of the alternating voltage applied to the electrodes divided by Æ2 2.2 breakdown voltage the voltage at which breakdown occurs in the rapidly applied voltage test or the highest voltage withstood for 20 s in the step-by-step method 2.3 electric strength the breakdown voltage divided by the dimension of the test piece across which the voltage was applied 2.4 central value the middle value of an odd number of results, or the mean of the middle two when arranged in order of magnitude 3 Identification of method Methods are identified according to the mode of applying the voltage and the nature of the material under test as indicated in Table 1. 4 Form of test pieces 4.1 General. If applicable the test piece shall be prepared under the conditions specified in the relevant British Standard for the material. The dimensions shall be as specified in 4.2 to 4.8; increases in the stated minimum dimensions may be necessary to avoid breakdown through the surrounding medium, i.e. flashover. 4.2 Test pieces for Methods C4.1A, C4.2A, 220A and 221A. The test piece shall be a disc not less than 1

Contents:

  • Foreword
  • Introduction
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS 903-C4-1983 PDF

BS 903-C4-1983 PDF

$52.07 $104.14