Methods of test for motor vehicle paints-Flexibility and adhesion
Scope: This Part of this British Standard describes flexibility and adhesion tests for paints for motor vehicles. The tests are grouped as follows: Group 1. Deformation test. Group 2. Cutting test. Group 3. Peeling test. 2 General 2.1 Methods for the evaluation of adhesion and flexibility are essentially qualitative rather than quantitative and are primarily employed for determinations in comparison with a specified standard of performance. Although adhesion and flexibility are fundamentally separate properties it is usual, for most practical purposes, to consider them as a combined function. Whilst these tests do not provide numerical expression of a single property, they are of practical value since they simulate deformation which may occur in service. 2.2 When testing a given paint system variations in results may be caused by the degree of cleanliness of the test panels and by the type and quality of the pretreatment used. 2.3 The testing methods may be divided into 3 groups as follows: Group 1. A test panel is deformed either gradually or under shock. The degree of deformation or shock is then related to the extent and pattern of the damage to the paint system. Group 2. The paint system is cut through to the substrate in single or multiple lines and the extent and pattern of the damage observed. Group 3. The paint film is peeled off by the use of adhesive tape. 3 Test panels Panels 150 mm × 100 mm or other convenient size, specified and pretreated in accordance with the requirements of BS 3900, Part A32) (note particularly Clause 2.2 and the special requirements of 4.2.2 herein) shall be coated in accordance with the requirements of BS 3900, Part A42), with the paint system to be tested. Normally steel panels are used and are essential for the cupping test (4.2.2), but otherwise it may be appropriate to use other substrates. The panels shall be aged, under normal laboratory conditions for 7 days, unless otherwise agreed. 4 Test procedures 4.1 General. The tests shall