Recommendations for the design of masonry structures to BS EN 1996-1-1 and BS EN 1996-2
Publishing information: This Published Document is published by BSI and came into effect on 31 July 2019. It was prepared by Subcommittee B/525/6, Use of masonry, under the authority of Technical Committee B/525, Building and civil engineering structures. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession This Published Document supersedes PD 6697:2010, which is withdrawn.
Information about this document: This Published Document is a background paper that gives non-contradictory complementary information for use in the UK with the following parts of BS EN 1996 Design of masonry structures, and their UK National Annexes: Part 1-1: General rules for reinforced and unreinforced masonry structures; Part 2: Design considerations, selection of materials and execution of masonry. This new edition of PD 6697 incorporates technical changes only. It does not represent a full review or revision of the standard, which will be undertaken in due course.
Use of this document: This publication is not to be regarded as a British Standard.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. The word “should” is used to express recommendations of this standard. The word “may” is used in the text to express permissibility, e.g. as an alternative to the primary recommendation of the clause. The word “can” is used to express possibility, e.g. a consequence of an action or an event. Notes and commentaries are provided throughout the text of this standard. Notes give references and additional information that are important but do not form part of the recommendations. Commentaries give background information.
Scope: This Published Document contains non-contradictory complementary information and additional guidance for use in the UK with BS EN 1996-1-1 and BS EN 1996-2. BS EN 1996-1-2 and BS EN 1996-3 are not specifically dealt with, but this Published Document may be relevant. Most of the material in this Published Document is taken from those parts of BS 5628-1, BS 5628-2, BS 5628-3 and BS EN 845 (all parts) that were not contradictory to the new BS EN 1996 series, but had to be withdrawn when those British Standards were withdrawn. This Published Document does not cover the detailing of components for seismic design.