BS PD CEN/TR 13121-5-2017 PDF

BS PD CEN/TR 13121-5-2017 PDF

GRP tanks and vessels for use above ground-Example calculation of a GRP-vessel

$204.47 $408.94 -50%
Publisher
isbn 9780580970108
Product Code: BS PD CEN/TR 13121-5
Stock In Stock
Published: 07/11/2017
Number of Pages: 60
File Size: 1 file, 2.7 MB

Available Options

Product Description

GRP tanks and vessels for use above ground-Example calculation of a GRP-vessel

Scope: This Technical Report gives guidance for the design of a vessel using the standard EN 13121-3 GRP tanks and vessels for use above ground. The calculation is done according to the advanced design method given in EN 13121-3:2016, 7.9.3 with approved laminates and laminate properties. 2 General Vessels or vessel structures may contain such structural elements or solutions for which this standard does not provide sufficient guidance. In that case, other methods shall be used in order to obtain a safe structure. This example calculation is based on a pressurized GRP vessel with an internal diameter of D 3000 mm. The cylindrical parts of the vessel are filament wound. Its bottom and roof are torispherical dished ends that are hand laid up using mixed laminates. Protection against medium attack is obtained by a chemical resistance layer (CRL). The tank is located outdoors in a seismic area. IMPORTANT – This example doesn’t cover all necessary verifications for the calculation of the GRP tank. Additional verifications have to be performed for the roof, the upper cylinder, etc. 3 Dimensions of the tank Sketch of the tank dimensions: PD CEN/TR 13121‑5:2017

Contents:

  • Introduction
  • Scope
  • 10.4.1 Proof of strength (Ultimate limit state)
  • 10.4.2 Proof of strain (Serviceability limit state)
  • 10.4.3 Stability proof (Ultimate limit state)
  • 10.5.1 Strength analysis (Ultimate limit state)
  • 10.5.2 Proof of strain (Serviceability limit state)
  • 10.5.3 Stability proof for the cylindrical shell tangential (Ultimate limit state)
  • 10.5.4 Critical buckling pressure for rings (Ultimate limit state)
  • 10.6.1 Analysis of the cylinder in axial direction
  • 10.6.2 Analysis of the cylinder in tangential direction
  • 11.1.1 Proof of strength
  • 11.1.2 Proof of strain
  • 11.2.1 Proof of strength
  • 11.2.2 Proof of strain
  • 12.2.1 Design value of actions
  • 12.2.2 Design value of corresponding resistance
  • 12.2.3 Verification
  • 12.3.1 Design value of actions

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD CEN/TR 13121-5-2017 PDF

BS PD CEN/TR 13121-5-2017 PDF

$204.47 $408.94