BS PD IEC TS 60695-2-21-2023 PDF

BS PD IEC TS 60695-2-21-2023 PDF

Fire hazard testing-Glowing/hot-wire based test methods. Fire containment test on finished units

$172.72 $345.44 -50%
Publisher
isbn 9780539059151
Product Code: BS PD IEC TS 60695-2-21
Stock In Stock
Published: 07/05/2023
Number of Pages: 34
File Size: 1 file, 6.3 MB

Available Options

Product Description

Fire hazard testing-Glowing/hot-wire based test methods. Fire containment test on finished units

Scope: This part of IEC 60695, which is a Technical Specification, specifies a fire containment test method for finished units. It is intended to verify the capability of containing of a fire event generated by an effective ignition source inside a finished unit. Unless otherwise specified by the relevant product standard, determination of the fire containment described in this document does not apply to any of the following: A single electrical component; A single electrical component when incorporated into a finished unit; Electrical installation products such as distribution boards, circuit protection devices, switchgear, controlgear, cable management system and electrical accessories (wiring devices). The test method described in this document does not apply to the following electrical connections: Low-power electrical connections contained in finished units, where the maximum power through the connection does not exceed 15 W. Soldered and welded electrical connections are exempted from the evaluations of this document. This document is intended to be used for evaluating the capability of fire containment of finished units, during the selection of finished units and in the design of finished units. The requirements, test method or test conditions of this document will not apply unless specifically referred to or included in the relevant publications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Evaluation of test results
  • 11 Test report
  • 12 Information to be given in the relevant product standard
  • Annex A (normative) Interpretations of the location of the cylindrical volume
  • Annex B (normative) NiCr wire application methods – Internal coil winding method
  • Annex C (normative) NiCr wire application methods – External winding method

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC TS 60695-2-21-2023 PDF

BS PD IEC TS 60695-2-21-2023 PDF

$172.72 $345.44