BS PD IEC TS 62882-2020 PDF

BS PD IEC TS 62882-2020 PDF

Hydraulic machines. Francis turbine pressure fluctuation transposition

$220.98 $441.96 -50%
Publisher
isbn 9780539019377
Product Code: BS PD IEC TS 62882
Stock In Stock
Published: 09/30/2020
Number of Pages: 156
File Size: 1 file, 20 MB

Available Options

Product Description

Hydraulic machines. Francis turbine pressure fluctuation transposition

Scope: IEC 62882, which is a Technical Specification, provides pressure fluctuation transposition methods for Francis turbines and pump-turbines operating as turbines, including: – description of pressure fluctuations, the phenomena causing them and the related problems; – characterization of the phenomena covered by this document, including but not limited to inter-blade vortices, draft tube vortices rope and rotor-stator interaction; – demonstration that both operating conditions and Thoma numbers (cavitation conditions) are primary parameters influencing pressure fluctuations; – recommendation of ways to measure and analyse pressure fluctuations; – identification of potential resonances in test rigs and prototypes; – identification of methods, to transpose the measurement results from model to prototype or provide ways to predict pressure fluctuations in prototypes based on statistics or experience; – recommendation of a data acquisition system, including the type and mounting position of model and prototype transducers and to define the similitude condition between model and prototype; – presentation of pressure fluctuation measurements comparing the model turbine and the corresponding prototype; – discussion of parameters used for the transposition from model to prototype, for example, the peak to peak value at 97 % confidence interval, the RMS value or the standard deviation in the time domain and the relation of main frequency and the rotational frequency in the frequency domain obtained by FFT; – discussion of the uncertainty of the pressure fluctuation transposition from model to prototype; – discussion of factors which influence the transposition, including those which cannot be simulated on the model test rig such as waterway system and mechanical system; – establishment of the transposition methods for different types of pressure fluctuations; – suggestion of possible methods for mitigating pressure fluctuation; – definition of the limitations of the specificat

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC TS 62882-2020 PDF

BS PD IEC TS 62882-2020 PDF

$220.98 $441.96