Fatigue. Fatigue testing of welded components. Guidance
Scope: This Technical Report gives guidance on best practice for fatigue testing under constant- or variable- amplitude loading of welded components in the medium- and high-cycle regimes, corresponding to applied loading that results in nominal stresses that do not exceed yield. Low-cycle fatigue testing under strain control is not specifically covered, although the same test specimens can be suitable for either low- or high-cycle fatigue testing. The different steps involved in the manufacture and preparation of the welded specimens and the final presentation and evaluation of the test results are also covered. This Technical Report does not cover corrosion or high-temperature fatigue testing. Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 failure criterion specimen damage chosen for ending the test 2.2 flank angle contact angle between the weld face and the plate at the weld toe 2.3 irregularity factor ratio of the number of mean crossings, N0, with positive slope to number of peaks or valleys in the given load history, Np p N N NOTE See Figure 1. 2.4 Maxima 2.4.1 maximum load range Fmax maximum load range encountered in a variable-amplitude applied load spectrum 2.4.2 maximum stress range max maximum stress range encountered in a variable-amplitude applied stress spectrum PD ISO/TR 14345:2012
Contents:
Foreword
Introduction
Scope
Annex A (informative) Weld profile measurement
Annex B (informative) Example of a fatigue data sheet for reporting the results of fatigue tests on