Vehicle security barriers. Low speed impact testing-Trolley impact test method for bollards
Publishing information: This PAS was sponsored by the UK Government’s Centre for the Protection of National Infrastructure (CPNI). Its development was facilitated by BSI Standards Limited and it was published under licence from The British Standards Institution. It came into effect on 31 July 2017. Acknowledgement is given to the following organizations that were involved in the development of this PAS as members of the steering group: ATG Access; Centre for the Protection of National Infrastructure (CPNI); D.J. Goode and Associates Limited; HORIBA MIRA Limited; Marshalls; MFD International Limited; Perimeter Security Suppliers Association (PSSA); Transport Research Laboratory (TRL Limited). The British Standards Institution retains ownership and copyright of this PAS. BSI Standards Limited as the publisher of the PAS reserves the right to withdraw or amend this PAS on receipt of authoritative advice that it is appropriate to do so. This PAS will be reviewed at intervals not exceeding two years, and any amendments arising from the review will be published as an amended PAS and publicized in Update Standards. This PAS is not to be regarded as a British Standard. It will be withdrawn upon publication of its content in, or as, a British Standard. The PAS process enables a standardization document to be rapidly developed in order to fulfil an immediate need in industry. A PAS can be considered for further development as a British Standard, or constitute part of the UK input into the development of a European or International Standard. Assessed capability. Users of this PAS are advised to consider the desirability of quality system assessment and registration against the appropriate standard in the BS EN ISO 9000 series by an accredited third‑party certification body. Test laboratory accreditation. Users of this PAS are advised to consider the desirability of selecting test laboratories that are accredited to BS EN ISO/IEC 17025 by a national or international accreditation body.
Use of this document: It has been assumed in the preparation of this PAS that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its methods are expressed as a set of instructions, a description, or in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element. iv • © The British Standards Institution 2017
Scope: This PAS describes a method for testing the performance of a single bollard, when subjected to a single impact using a 2 500 kg impact trolley at a speed of 16 km/h or 32+3 –1 km/h. PAS 170‑1 does not cover testing the performance of blockers, planters or street furniture. It is not equivalent to a full‑scale vehicle impact test method. It does not cover the performance of a test item or its control apparatus when subjected to: blast explosion, ballistic impact, manual attack with the aid of tools or electrical manipulation/attack through a control system. This PAS is for use by manufacturers, distributers or specifiers of bollards. NOTE Full‑scale vehicle impact test method is defined in 3.7. +3 –1
Contents:
- Annex A (normative) Impact trolley 20
- Annex B (normative) Impact trolley calibration 22
- Annex C (normative) Soil properties and standard backfill 26