Prerequisite programmes for food safety in the manufacture of food and feed for animals
This Publicly Available Specification (PAS) has been prepared by the British Standards Institution (BSI) to specify requirements for prerequisite programmes (PRPs) to assist in controlling animal food and feed safety hazards The development of this PAS was sponsored by SSAFE (Safe Supply of Affordable Food Everywhere: http://www.ssafe-food.org). Technical Author representing SSAFE: David Harlan (Cargill) Acknowledgement is given to the following organizations and individuals that supported the development of this PAS through participation on the Steering Group: • Agricultural Industries Confederation Simon Williams • Cargill David Merriweather • Food and Agriculture Organization of the United Nations Daniela Battaglia • Foundation for Food Safety Certification Cor Groenveld • Land O’Lakes Beth Featherston • Nestlé Pablo Carrion • Nutreco Hans Smelt SSAFE, BSI, the Technical Author and Steering Group greatly appreciate the considerable input during the development of this PAS from numerous individuals and organizations around the world.
Publishing information: This PAS has been prepared and published by BSI, which retains its ownership and copyright. BSI reserves the right to withdraw or amend this PAS on receipt of authoritative advice that it is appropriate to do so. This PAS will be reviewed at intervals not exceeding two years, and any amendments arising from the reviews will be published as an amended PAS and publicized in Update Standards. This PAS is not to be regarded as a British Standard, European Standard or International Standard. In the event that this PAS is put forward to form the basis of a full British Standard, European Standard or International Standard, it will be withdrawn.
Use of this document: It has been assumed in the preparation of this PAS that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This PAS specifies requirements to be considered, specifically addressing: a) site and associated utilities; b) processes, including workspaces and employee facilities; c) supplies of air, water and other utilities; d) supporting services, including waste disposal; e) suitability of equipment and its accessibility for cleaning, maintenance and preventive maintenance; f) management of ingredients; g) management of medications; h) measures for the prevention of contamination; i) sanitation; j) pest control; k) personnel hygiene; In addition, this PAS adds other aspects that are considered relevant to animal food and feed manufacturing operations: l) rework; m) product withdrawal procedures; n) warehousing and transportation; o) formulation of products; p) specifications for services; q) training and supervision of personnel; r) product information; s) food defence, biovigilance and bioterrorism.
Contents:
- Foreword
- Introduction
- 1 Scope
- 2 Terms and definitions
- 3 Sites
- 3.1 General requirements
- 3.2 Buildings
- 3.3 Environment
- 3.4 Locations of sites
- 4 Processes and workspaces
- 4.1 General requirements
- 4.2 Workflow
- 4.3 Structures and fittings
- 4.4 Equipment
- 4.5 Laboratory facilities
- 4.6 Temporary and/or mobile structures and equipment
- 4.7 Storage of materials
- 5 Utilities
- 5.1 General requirements
- 5.2 Water supply
- 5.3 Boiler chemicals
- 5.4 Ventilation
- 5.5 Air and compressed gas systems
- 5.6 Lighting
- 6 Waste disposal
- 6.1 General requirements
- 6.2 Containers for waste
- 6.3 Waste management and removal
- 6.4 Drains and drainage
- 7 Equipment suitability, cleaning and maintenance