Scheme for the application of European Standards for intrusion and hold-up alarm systems
Publishing information: This Published Document is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2017. It was prepared by Subcommittee GW/1/2, Installed alarm systems, under the authority of Technical Committee GW/1, Electronic security systems. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession The recommendations of this Published Document become effective immediately and can be used as soon as suitable products are available to comply with its recommendations. However, the technical committee recognizes that suppliers of products and services within the scope of this standard will require time to comply. For this reason, PD 6662:2010 will be withdrawn on 31 May 2019. Relationship with other publications A series of European Standards for intrusion and hold‑up alarm systems (I&HAS) is being produced which will eventually replace a number of British Standards for intrusion and hold‑up alarm systems. Most European Standards in the series have been published, others are in draft format, and work has not yet started on the remainder. This Published Document has been developed to enable users, specifiers and insurance companies to specify, and security companies to install, I&HAS to those parts of the European standards which are already published and to those European standards which exist in a mature draft form. The publication of this document is intended to enable the published European Standards and draft standards to be introduced in a controlled and consistent way across the industry, including BS EN 50131‑1, Alarm systems – Intrusion systems – Part 1: System requirements. Attention is drawn to BS 7671, The IET Wiring Regulations.
Information about this document: This is a full revision of this Published Document, and introduces changes due to the update of British and European standards and the availability of BS 9263.
Presentational conventions: The provisions in this Published Document are presented in roman (i.e. upright) type. Its recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: Terms, definitions and abbreviations Scheme content Claims of compliance Identity cards Risk assessment Annex A (normative) UK specific recommendations Annex B (informative) UK specific guidance Table B.1 — Duration of alternative power supply Annex C (informative) Additional guidance Bibliography Contents Page This document comprises a front cover, and inside front cover, pages i to ii, pages 1 to 10, an inside back cover and a back cover. PD 6662:2017 Publishing information This Published Document is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 August 2017. It was prepared by Subcommittee GW/1/2, Installed alarm systems, under the authority of Technical Committee GW/1, Electronic security systems. A list of organizations represented on these committees can be obtained on request to their secretary. Supersession The recommendations of this Published Document become effective immediately and can be used as soon as suitable products are available to comply with its recommendations. However, the technical committee recognizes that suppliers of products and services within the scope of this standard will require time to comply. For this reason, PD 6662:2010 will be withdrawn on 31 May 2019. Relationship with other publications A series of European Standards for intrusion and hold‑up alarm systems (I&HAS) is being produced which will eventually replace a number of British Standards for intrusion and hold‑up alarm systems. Most European Standards in the series have been published, others are in draft format, and work has not yet started on the remainder. This Published Document has been developed to enable users, specifiers and insurance companies to specify, and security companies to install, I&HAS to those parts of the European standards which are already published and to those European standards which exist in a mature draft form. The publication of this document is intended to enable the publishe