Application of fire safety engineering principles to the design of buildings-Spread of smoke and toxic gases within and beyond the enclosure of origin (Sub-system 2)
Publishing information: This Published Document is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 March 2019. It was prepared by Technical Committee FSH/24, Fire safety engineering. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This Published Document supersedes PD 7974-2:2002, which is withdrawn. Relationship with other publications This Published Document is one of a series of documents published under the Fire Standards Policy Committee, and is a supporting document to BS 7974, Application of fire safety engineering principles to the design of buildings — Code of practice. Other documents in the series are: PD 7974-1: Initiation and development of fire within the enclosure of origin; PD 7974-3: Structural response to fire and fire spread beyond the enclosure of origin ; PD 7974-4: Detection of fire and activation of fire suppression systems; PD 7974-5: Fire service intervention; PD 7974-6: Evacuation; PD 7974-7: Probabilistic risk assessment; Where appropriate, references to relevant standards are provided in order to assist the reader in understanding the design methodologies presented and to compare different approaches or sources of data. It is therefore important that PD 7974-2 is not used in isolation and reference is made to the relevant standards, particularly in relation to additional notes and subclauses describing its application.
Information about this document: This is a full revision of the document, and introduces the following principal changes: greater clarity regarding smoke control design principles, application and procedures; new information on the practical application of natural and mechanical smoke control, and the use of smoke barriers; rationalization of guidance on computer simulation modelling principles, as the intent of this guide is smoke control rather than computer fire modelling; where practicable, explicit acknowledgements of the inherent assumptions and limitations of underpinning design correlations; revised and new correlations with respect to spill plumes and the axisymmetric plume; new figures to aid the correct use of design correlations; calculation of smoke detection time for activating smoke control; greater clarity on design considerations for smoke reservoir size, and the interaction between sprinklers/smoke ventilation; and PD 7974‑2:2019 PUBLISHED DOCUMENT ii © THE BRITISH STANDARDS INSTITUTION 2019 – ALL RIGHTS RESERVED improved reference data for smoke and toxic gas yields.
Use of this document: As a guide, this Published Document takes the form of guidance and recommendations. It should not be quoted as if it were a specification or a code of practice and claims of compliance cannot be made to it. This publication is not to be regarded as a British Standard.
Presentational conventions: The guidance in this Published Document is presented in roman (i.e. upright) type. Any recommendations are expressed in sentences in which the principal auxiliary verb is “should”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This Published Document provides guidance on the application of fire safety engineering principles for the treatment of smoke movement, control and management problems. The guidance is intended primarily for professional engineers with a responsibility for the design or assessment of fire safety in buildings.