Food analysis. Determination of pesticide residues by GC-MS. Retention times, mass spectrometric parameters and detector response information
Scope: This Technical Report lists mass spectrometric parameters which are useful for the application of European Standards for the determination of pesticide residues in foods that use GC-MS, such as the following standards: EN 1528 (all parts), Fatty food — Determination of pesticides and polychlorinated biphenyls (PCBs); EN 12393 (all parts), Foods of plant origin — Multiresidue methods for the gas chromatographic determination of pesticide residues; EN 15662, Foods of plant origin — Determination of pesticide residues using GC-MS and/or LC-MS/MS following acetonitrile extraction/partitioning and clean-up by dispersive SPE — QuEChERS-method. To facilitate the determination of pesticides and/or metabolites using GC-MS, Table 1 specifies the diagnostic ions suitable for quantification, which can be used. Analyte specific parameters for gas chromatographic determination of pesticides 2.1 General All values indicated in Table 1 were acquired using GC-MS, GC-ECD or GC-NPD systems under the experimental conditions as outlined in 2.2. Comparative investigations showed that these parameters can be transferred simply on instruments of other types of the same or other manufacturers [1]. 2.2 GC-MS, GC-ECD and GC-NPD Parameters The following GC operating conditions have been proven to be satisfactory. This is an example for appropriate experimental conditions. Equivalent conditions may be used if they can be shown to lead to the same results. Gas chromatograph Agilent model 6890 Carrier gas Helium, constant flow 1,0 ml/min (typical pressure at 70 °C is 61 kPa) Injection technique Pulsed splitless, 200 kPa; Pulse time 1,0 min Injector temperature 240 °C Injection liner single taper, splitless (Agilent 5181-3316) Injection volume 1 µl or 2 µl Purge Gas Helium; purge flow to split vent 50 ml/min; Purge time 1,5 min Column Fused silica capillary column HP-5MS, length 30 m, inner diameter 0,25 mm, film thickness 0,25 µm (Agilent Nr. 19091S-433) Temperature programme 2 min 70 °C, p
Contents:
- Foreword
- Introduction
- Scope
- Bibliography