BS PD CEN/TS 16800-2020 PDF

BS PD CEN/TS 16800-2020 PDF

Guideline for the validation of physico-chemical analytical methods

$204.47 $408.94 -50%
Publisher
isbn 9780539129403
Product Code: BS PD CEN/TS 16800
Stock In Stock
Published: 01/08/2021
Number of Pages: 52
File Size: 1 file, 2.7 MB

Available Options

Product Description

Guideline for the validation of physico-chemical analytical methods

Scope: This document describes an approach for the validation of physico-chemical analytical methods for environmental solid matrices and water. The guidance in this document addresses the initial description of the method and two different validation approaches, in increasing order of complexity. These are: a) method development, if the method is developed by the laboratory, or conditions of adoption, if the method is a standardized protocol adopted by the laboratory; b) validation at the level of single laboratories (within-laboratory validation); c) method validation at the level of several laboratories (between-laboratory or inter-laboratory validation), with a focus on methods that are sufficiently mature and robust to be applied not only by a few expert laboratories but by laboratories operating at the routine level. The concept is strictly hierarchical, i.e. a method shall fulfil all criteria of within-laboratory validation before it can enter the validation protocol of the between-laboratory. This document is applicable to the validation of a broad range of quantitative physico-chemical test methods for the analysis of water (including drinking water, surface water, groundwater, waste water, marine water), and of solid environmental matrices, such as soil, sludge, liquid and solid waste, sediment and biota. It is intended for standardized protocols adopted by a laboratory, and either for test methods aiming at substances that have recently become of interest or for test methods applying recently developed technologies. The minimal requirements that are indispensable for the characterization of the fitness for the intended purpose of an analytical method are: selectivity, precision, trueness, performances characteristics and measurement uncertainty. The aim of validation is to prove that these requirements are met. In this document after the definitions (Clause 3) and description of the principles (Clause 4) a toolbox is given describing the relevant performance cha

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD CEN/TS 16800-2020 PDF

BS PD CEN/TS 16800-2020 PDF

$204.47 $408.94