BS PD IEC PAS 62840-3-2021 PDF

BS PD IEC PAS 62840-3-2021 PDF

Electric vehicle battery swap system-Particular safety and interoperability requirements for battery swap systems operating with removable RESS/battery systems

$172.72 $345.44 -50%
Publisher
isbn 9780580954726
Product Code: BS PD IEC PAS 62840-3
Stock In Stock
Published: 10/29/2021
Number of Pages: 44
File Size: 1 file, 1.7 MB

Available Options

Product Description

Electric vehicle battery swap system-Particular safety and interoperability requirements for battery swap systems operating with removable RESS/battery systems

Scope: This document applies to battery swap systems for removable RESS of electric road vehicle when connected to the supply network, with a rated supply voltage up to 480 V AC or up to 400 V DC, for battery systems with a rated voltage up to 120 V DC. NOTE 1 In the following countries, the acceptable nominal supply voltage is up to 600 V AC: CA, US. This document applies to battery swap systems for removable RESS/EV where the removable RESS/EV is stored for the purpose of transfer power between the battery swap station and removable RESS/EV. Requirements for bidirectional energy transfer DC to AC are under consideration and are not part of this document. This document applies to: – battery swap systems supplied from on-site storage systems (for example buffer batteries etc); – manual, mechanically assisted and automatic systems; – battery swap systems intended to supply removable battery systems having communication allowing to identify the battery system characteristics; – battery swap systems intended to be installed at an altitude of up to 2 000 m. The aspects covered in this document include: – requirements for power transfer between the battery systems; – additional requirements for communication; – the connection to supply network. Additional requirements may apply to special locations. This document does not apply to: – safety requirements for mechanical equipment covered by ISO 10218 (all parts); – locking compartments systems providing AC socket-outlets for the use of manufacturer specific voltage converter units and manufacturer specific battery systems; – safety aspects related to maintenance; – electrical devices and components which are covered by their specific product standards; – trolley buses, rail vehicles; – any on-board equipment which is covered by ISO; – EMC requirements for on-board equipment while connected to the supply, which are covered by IEC 61851-21-1. Requirements for battery swap systems using protective measures as covered by 410 of IEC 6

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 6.8 Automation level
  • 12.3 IP degrees
  • Annex A (informative) Use cases
  • Annex B (informative) Examples of BSS wirings for removable battery systems

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC PAS 62840-3-2021 PDF

BS PD IEC PAS 62840-3-2021 PDF

$172.72 $345.44