BS PD IEC/TR 62836-2013 PDF

BS PD IEC/TR 62836-2013 PDF

Measurement of internal electric field in insulating materials. Pressure wave propagation method

$105.41 $210.82 -50%
Publisher
isbn 9780580815898
Product Code: BS PD IEC/TR 62836
Stock In Stock
Published: 09/25/2013
Number of Pages: 16
File Size: 1 file, 1.8 MB

Available Options

Product Description

Measurement of internal electric field in insulating materials. Pressure wave propagation method

Scope: IEC/TR 62836, which is a technical report, contains an efficient and reliable procedure to test the internal electric field in the insulating materials used for high-voltage applications using the pressure wave propagation (PWP) method. It is suitable for a sample with homogeneous insulating materials and an electric field higher than 1 kV/mm, but it is also depended on the thickness of sample and the pressure wave generator. Terms, definitions and abbreviations For the purposes of this document, the following terms, definitions and abbreviations apply. 2.1 Terms and definitions 2.1.1 pressure wave propagation PWP propagation of wave generated by the action of a pressure pulse 2.2 Abbreviations LIPP laser induced pressure pulse PIPP piezoelectric induced pressure pulse Principle of the method The principle of the PWP method is shown schematically in Figure 1. The space charge in the dielectric and the interface charge are forced to move by the action of a pressure pulse wave. The charge displacement then induces an electrical signal in the measuring circuit which is an image of the charge distribution in the short-circuit current measurement condition. The expression for the short-circuit signal is dx t t p E t d∫ ∂ ∂ = ) , ( ) ( B ) ( (1) where E(x) is the electric field distribution in the sample; d is the thickness of sample; p(x, t) is the pressure pulse wave in the sample, which depends on the electrode materials, dielectric sample material, the condition of coupling on the interface, etc.; C0 is the sample capacitance without the action of pressure pulse wave. C0 depends on the thickness of sample, and its surface area which is equal to the area of action of pressure pulse wave. The constant B = x (1 −a ε ⁄ ) only depends on the characteristics of the dielectric materials. For heterogeneous dielectric materials, B is a function of space. For homogeneous dielectric materials, B is not a function of space and can be put in front of the integral. In this proposit

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC/TR 62836-2013 PDF

BS PD IEC/TR 62836-2013 PDF

$105.41 $210.82