BS PD IEC/TR 62854-2014 PDF

BS PD IEC/TR 62854-2014 PDF

Sharp edge testing apparatus and test procedure for lighting equipment. Tests for sharpness of edge

$90.17 $180.34 -50%
Publisher
isbn 9780580817663
Product Code: BS PD IEC/TR 62854
Stock In Stock
Published: 02/14/2014
Number of Pages: 14
File Size: 1 file, 1.1 MB

Available Options

Product Description

Sharp edge testing apparatus and test procedure for lighting equipment. Tests for sharpness of edge

Scope: This technical report details a test procedure and test equipment that may be used to assist the assessment of the risk of hazardous sharp edges that may be exposed to the user or installer of lighting equipment. Test equipment Sharp-edge tester – The instrument consists essentially of a handle with a pivoted arm attached. A constant-tension spring secured to the handle is used to apply a steady force to the arm. The arm head is a piece of cylindrical steel, with an outside diameter of 12,7 mm and a length of 19 mm, located at the end of the adjustable arm. The arm head is to be wrapped with three layers of tape, the two outer layers act as sensing tapes; the inner layer acts as an indicating tape. Alternatively, the tapes are to be applied to a maximum 15,9 mm diameter removable sleeve (cap) that is placed onto the 12,7 mm steel head. See Figure 1 or 2. Indicating tape (inner layer) – 19,1 mm wide, adhesive backed, single-adhesive coated, vinyl foam tape, black in colour, having the tape properties given in Table 1. Sensing tape no. 2 (middle layer) – 19,1 mm wide, double-adhesive coated, vinyl foam tape, white in colour, having the tape properties given in Table 1. Sensing tape no. 1 (outer layer) – 19,1 mm wide, single-adhesive coated skived tetra- fluorethylene tape – natural colour, having the tape properties given in Table 1. The skived tetrafluorethylene backing (film) is shaved in a thin layer from a cylindrical block of material. Calibration equipment – A weight (mass) that can exert 6,672 ± 0,133 N and a length of string. Calibration The sharp edge tester shall be calibrated so that 6,7 ± 0,133 N force is present at the centre of the head when the arm is between stops. The length of the arm is to be adjustable for calibration purposes. For special evaluations, the force may be adjusted to a different value. See Figure 3 for a typical calibration procedure were, the length of the arm is to be adjustable for calibration purposes: The adjustment set screws th

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC/TR 62854-2014 PDF

BS PD IEC/TR 62854-2014 PDF

$90.17 $180.34