BS PD IEC TS 62600-30-2018 PDF

BS PD IEC TS 62600-30-2018 PDF

Marine energy. Wave, tidal and other water current converters-Electrical power quality requirements

$194.31 $388.62 -50%
Publisher
isbn 9780580973277
Product Code: BS PD IEC TS 62600-30
Stock In Stock
Published: 09/04/2018
Number of Pages: 46
File Size: 1 file, 1.2 MB

Available Options

Product Description

Marine energy. Wave, tidal and other water current converters-Electrical power quality requirements

Scope: This part of IEC 62600 includes: definition and specification of the quantities to be determined for characterizing the power quality of a marine energy (wave, tidal and other water current) converter unit; measurement procedures for quantifying the characteristics of a marine energy (wave, tidal and other water current) converter. The measurement procedures are valid for a single marine energy converter (MEC) unit (or farm) with three-phase grid or an off-grid connection. The measurement procedures are valid for any size of MEC unit, though this document only requires MEC unit types intended for PCC (Point of Common Coupling) at Medium Voltage (MV) or High Voltage (HV) to be tested and characterized. In addition, a simplified measurement and reporting procedure is outlined for MEC units connected at Low Voltage (LV) networks. MV–connected and LV-connected devices are defined as: MV connected units – typically multiple three-phase MEC units operating as a marine power farm and delivering power through a HV or MV network; LV connected units – typically single-phase or three-phase units deployed in isolated, hybrid or micro-grid type systems supplying small-scale loads. Considering the nascent status of the marine energy sector, the following limitations of this document are to be recognized: voltage fluctuations under switching operation – the current revision only considers voltage fluctuations under continuous operation; resource classifications – to categorize the measured flicker quantities, various resource classes are suggested only as guidelines. The user is advised to use these resource classes judiciously. The measurement procedures are designed to be as non-site-specific as possible so that power quality characteristics measured at a test site, for example, can be considered valid at other sites also providing the same MEC unit configuration and operation modes (for example control parameters). If the configuration or operation mode is changed in any way th

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
BS PD IEC TS 62600-30-2018 PDF

BS PD IEC TS 62600-30-2018 PDF

$194.31 $388.62