Washers for unified hexagons for aircraft (primarily for packing purposes)
Publishing information: This British Standard is published by BSI Standards Limited, under licence from The British Standards Institution, and came into effect on 31 January 2016. It was prepared by Technical Committee ACE/12, Aerospace fasteners and fastening. A list of organizations represented on this committee can be obtained on request to its secretary. Supersession This British Standard supersedes BS SP 122 to 125:1958+A2:2011, which is withdrawn.
Information about this document: This is a full revision of the standard, and introduces the following principal change: a protective finish option has been added to aluminium washers SP124 and SP125.
Use of this document: It has been assumed in the preparation of this British Standard that the execution of its provisions will be entrusted to appropriately qualified and experienced people, for whose use it has been produced.
Presentational conventions: The provisions of this standard are presented in roman (i.e. upright) type. Its requirements are expressed in sentences in which the principal auxiliary verb is “shall”. Commentary, explanation and general informative material is presented in smaller italic type, and does not constitute a normative element.
Scope: This British Standard specifies the materials, dimensions and finish of mild steel, corrosion-resisting steel and aluminium alloy washers suitable for use with bolts with Unified hexagons for aircraft. The washers are intended primarily for use for packing purposes. Provision has been made for oversize bore washers for use when used in conjunction with oversize plain shank bolts, with the oversize washer being fitted onto the bolt head side of the clamped joint.
Contents:
- Foreword
- Scope
- Bibliography