ISO 19918-2017 PDF

ISO 19918-2017 PDF

Protective clothing - Protection against chemicals - Measurement of cumulative permeation of chemicals with low vapour pressure through materials

$13.00 $26.00 -50%
Product Code: ISO 19918
Stock In Stock
Edition: 1ST
Published: 09/2017
Number of Pages: 24
File Size: 1 file, 581 Bytes

Available Options

Product Description

Protective clothing - Protection against chemicals - Measurement of cumulative permeation of chemicals with low vapour pressure through materials

Introduction: When assessing the performance of personal protective equipment (PPE) against chemical risks, it is clearly important to determine the ability of PPE materials to resist chemical ingress. The term "ingress" is used here specifically so as not to distinguish between penetration and permeation. Penetration is ingress through physical holes in the fabric such as pores, stitch-holes, and gaps in a protective coating. Penetration is usually quite a rapid process, leading to the ingress of chemical within a matter of minutes, whereas permeation is usually a slower process with molecular diffusion through a polymer or elastomer. However, from the perspective of the wearer of PPE (gloves, footwear, protective clothing) the mechanism of ingress is far less relevant than the fact that a quantity of chemical may at some point migrate through the fabric of the personal protective equipment. Standards to measure permeation are designed to measure the performance of materials that include a polymer or elastomer as the movement in these materials is at the molecular level. However, although they are intended to measure movement of chemicals at a molecular level, it may be difficult to differentiate between penetration and permeation in materials with small pores, pinholes, and gaps in coating. A number of standards, including ISO 6529, EN 16523-1 and ASTM F739, measure permeation of chemicals that are volatile and/or soluble in water or other liquid or gaseous collection media. In the above

Scope: This document describes laboratory test methods to determine the resistance of materials, closures, and seams used in personal protective equipment (PPE) to permeation by solid or liquid chemicals with low vapour pressure (less than 133,322 Pa at 25 °C) and/or insolubility in water or other liquids commonly used as collection media. These chemicals that are often part of pesticide formulations and other mixtures cannot be measured using other standards for measuring permeation. This test method is suitable for field strength and concentrated pesticide formulations as well as other mixtures in which the active ingredient is a chemical with low vapour pressure and/or low solubility in commonly used liquid and gaseous collection media. This test method is not intended to be used in place of standards such as ISO 6529, EN 16523-1 and ASTM F739, which measure permeation of chemicals that are either volatile or soluble in water or other liquids that do not interact with the material being tested. This document is not suitable for measurement of volatile chemicals that may evaporate before the chemical analysis is complete. The degree of contamination depends on numerous factors, such as type of exposure, application technique, and chemical formulation. As the level of exposure can vary considerably, this method is designed to rate relative performance of PPE materials for different durations. This method is designed to measure cumulative permeation. Breakthrough time cannot be measured by this method. This test method does not measure resistance to penetration or degradation. The test method standard may be used for the evaluation of PPE materials that are new or those for which the product standard requires treatment, such as laundering or simulated abrasion. Details of the treatment shall be reported.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19918-2017 PDF

ISO 19918-2017 PDF

$13.00 $26.00