ISO 19932-3-2025 PDF

ISO 19932-3-2025 PDF

Equipment for crop protection-Knapsack sprayers-Part 3: Inspection of knapsack sprayers in use

$31.50 $63.00 -50%
Product Code: ISO 19932-3
Stock In Stock
Edition: 1.
Published: 04/2025
Number of Pages: 14
File Size: 1 file, 1 Byte

Available Options

Product Description

Equipment for crop protection — Knapsack sprayers — Part 3: Inspection of knapsack sprayers in use

Introduction: There are three main reasons for inspection of the use of knapsack sprayers, which are the most widely used means worldwide of applying plant protection products (PPPs): — less potential risk to the operator; — less potential risk of environmental contamination by PPPs; and — good control of the pest with the minimum possible input of PPPs. In order to use PPPs in agricultural production safely, the requirements and test methods for knapsack sprayers in use should be defined. This is a relevant step after having standardized minimum requirements for new knapsack sprayers, in respect of safety hazards and potential risks of environmental contamination (see ISO 19932-1:— and ISO 19932-2:—). Standardizing the requirements and methods for inspection of sprayers in use takes into consideration not only the original performance of the sprayer, but also its use, care and maintenance. This is the logical link to ensure the continued benefit arising from the supply of new sprayers of good quality. The inspection of sprayers in use can be a mandatory requirement or adopted on a voluntary basis. In both cases, further requirements, outside the scope of this document, are necessary for the management of inspections. These include, for example, requirements for the competence of persons carrying out inspections and the frequency of inspections. NOTE National or regional regulations can also apply concerning the qualifications and competence of inspectors. © ISO 2025 – All rights reserved

Scope: This document specifies the requirements and test methods for inspection of the use of knapsack sprayers carried on the back or shoulder of the operator for use with plant protection products (PPPs). The requirements relate mainly to the condition of the sprayer with respect to its potential risk to the operator and the environment and its performance to achieve good application. This document is applicable to lever-operated knapsack sprayers, knapsack compression sprayers and knapsack sprayers driven by an engine or electric motor using hydraulic pressure atomisation of the spray liquid, intended for use primarily in agriculture, forestry and horticulture, with a nominal volume of more than 6,0 l. It does not apply to — knapsack combustion engine-driven air-blast sprayers, which are covered in ISO 28139:2019/Amd 1:2024, — controlled droplet application equipment utilizing rotary atomisers, or — portable application equipment for spatial application (such as foggers).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19932-3-2025 PDF

ISO 19932-3-2025 PDF

$31.50 $63.00