ISO 19973-4-2014 PDF

ISO 19973-4-2014 PDF

Pneumatic fluid power - Assessment of component reliability by testing - Part 4: Pressure regulators

$71.50 $143.00 -50%
Product Code: ISO 19973-4
Stock In Stock
Edition: 2ND
Published: 03/01/2014
Number of Pages: 24
File Size: 1 file, 668 Bytes

Available Options

Product Description

Pneumatic fluid power - Assessment of component reliability by testing - Part 4: Pressure regulators

Introduction: In pneumatic fluid power systems, power is transmitted and controlled through a gas under pressure within a circuit. Pneumatic fluid power systems are composed of components and are an integral part of various types of machines and equipment. Efficient and economical production requires highly reliable machines and equipment. Within the ISO 19973 series, this part is intended to provide requirements and test conditions that permit the assessment of the inherent reliability of pneumatic pressure regulators. It is necessary that machine producers know the reliability of the components that make up their machine’s pneumatic fluid power system. Knowing the reliability characteristic of the component, the producers can model the system and make decisions on service intervals, spare parts inventory, and areas for future improvements. There are three primary levels in the determination of component reliability: a) preliminary design analysis — finite element analysis (FEA), failure mode and effect analysis (FMEA); b) laboratory testing and reliability modelling — physics of failure, reliability prediction, pre- production evaluation; c) collection of field data — maintenance reports, warranty analysis. Each level has its application during the life of a component. A preliminary design analysis is useful to identify possible failure modes and eliminate them or reduce their effect on reliability. When prototypes are available, in-house laboratory reliability tests are run and initial

Scope: This part of ISO 19973 provides test procedures for assessing the reliability of pneumatic pressure regulators by testing and the methods of reporting the results of testing. General test conditions and the calculation method are provided in ISO 19973-1. The methods specified in ISO 19973-1 apply to the first failure, as obtained with the three-points moving average (3PMA) method, without repairs, but excluding outliers. The lifetime of pneumatic pressure regulators is usually given as a number of cycles. Therefore, whenever the term “time” is used in this part of ISO 19973, this variable shall be understood as either cycles or time. This part of ISO 19973 applies to manually adjustable and remote-piloted pressure regulators, both relieving and non-relieving. This part of ISO 19973 does not apply to pressure regulators that have a permanent bleed. This part of ISO 19973 also specifies test equipment and failure criteria (threshold levels) for tests to assess the reliability of pneumatic pressure regulators. The life determined by the method in this part of ISO 19973 and in ISO 19973-1 will be more closely related to applications that have a large variation in flow rate. NOTE See Annex A for a flow chart illustrating the test procedure specified in this part of ISO 19973.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19973-4-2014 PDF

ISO 19973-4-2014 PDF

$71.50 $143.00