ISO 19996-2024 PDF

ISO 19996-2024 PDF

Charge conditioning of aerosol particles for particle characterization and the generation of calibration and test aerosols

$145.50 $291.00 -50%
Product Code: ISO 19996
Stock In Stock
Edition: 1.
Published: 10/2024
Number of Pages: 66
File Size: 1 file, 6 Bytes

Available Options

Product Description

Charge conditioning of aerosol particles for particle characterization and the generation of calibration and test aerosols

Introduction: Charge conditioning of aerosol particles is the crucial process of establishing a known, size-dependent charge distribution on aerosol particles. Different designs for charge conditioners exist. In charge conditioners, aerosol particles are exposed to a cloud of ions of either both positive and negative polarities (bipolar charge conditioners) or a single polarity (unipolar charge conditioners). The transport of the ions to the aerosol particles can either be driven by Brownian motion of the ions (diffusion charging) or by an electrical field (field charging). Since field charging is strongly biased by a particle’s electrical properties (namely the relative permittivity), diffusion charging is generally used to condition aerosol particles: — for particle size distribution measurement with the differential mobility analysing system (DMAS); — for particle size classification with the differential electrical mobility classifier (DEMC). Several parameters determine whether or not charge conditioning achieves its goal of either generating a mathematically describable bipolar steady-state charge distribution or a quantifiable unipolar mean charge. Examples for such parameters are the ion concentration, the particle concentration, the residence time of the particles in the ion cloud, the ion mass distribution or the ion mobility distribution. However, there is no standard methodology to specify the performance of charge conditioners. The electrical mobility of aerosol particles is a

Scope: This document specifies requirements and provides guidance for the use of charge conditioners for aerosol particles, especially for particle characterization and for the generation of calibration and test aerosols. This document provides a methodology to specify the performance of charge conditioners and for adequate quality control, with respect to their application in: — particle size and concentration measurement with differential mobility analysing systems (DMAS); —particle size classification with differential electrical mobility classifiers (DEMC). For these applications, this document covers particle charge conditioning for particle sizes ranging from approximately 1 nm to 1 µm and for particle number concentrations at the inlet of the charge conditioner up to approximately 107 cm-3. This document does not address specific charge conditioner designs or other applications besides those specified in Clause 1. Radiation safety for charge conditioners with radioactive sources or x-ray tubes is not covered by this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19996-2024 PDF

ISO 19996-2024 PDF

$145.50 $291.00