ISO 20291-1-2021 PDF

ISO 20291-1-2021 PDF

Air cargo-Restraint slings-Part 1: Design and testing

$96.50 $193.00 -50%
Product Code: ISO 20291-1
Stock In Stock
Edition: 1ST
Published: 06/2021
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Air cargo — Restraint slings — Part 1: Design and testing

Introduction: The aim of this document is to standardize the design and testing requirements for air cargo restraint sling assemblies used as an alternate to restraint straps for tie-down of cargo on board civil transport aircraft. The civil aviation requirements referred to in this document are those relating to the design of transport aircraft. They constitute the set of design requirements internationally agreed in the application of International Civil Aviation Organization (ICAO) Annex 6, Airworthiness of aircraft, to the Convention on International Civil Aviation. Throughout this document, the minimum essential criteria are identified by use of the key word "shall". Recommended criteria are identified by use of the key word “should” and, while not mandatory, are considered of primary importance in providing safe air cargo restraint sling assemblies. Deviation from the recommended criteria should only occur after careful consideration and thorough service evaluation have shown that alternate methods can be used to provide an equivalent level of safety. The requirements of this document are expressed in the applicable SI units, with approximate inch- pound units conversion between brackets for convenience in countries using that system. Sling or cable assemblies made of steel wire rope are intended to be used in lieu of cargo restraint straps meeting the requirements of ISO 16049-1, where straps inherent elongation under tension appears unadvisable for a given tie-down arrangement. Typ

Scope: This document specifies the design criteria and testing methods adequate to guarantee the ultimate strength and operational dependability of cargo restraint sling assemblies made of steel wire rope, with a 22,25 kN (5 000 lbf) rated ultimate load capability, as can be used by the airline industry in order to restrain on board civil transport aircraft during flight, including the following: — cargo loaded and tied down onto airworthiness approved air cargo pallets, themselves restrained into aircraft lower deck, main deck or upper deck cargo systems and meeting the requirements of ISO 8097 (NAS 3610) or ISO 21100, or — non-unitized individual pieces of cargo, or pieces of cargo placed onto an unrestrained ("floating") pallet into either lower deck, main deck or upper deck containerized cargo compartments of an aircraft, to be restrained onto aircraft structure attachment (tie-down) points. Two types of wire rope restraint slings are defined: a) type A: adjustable length restraint sling assemblies, including a tension retaining device and termination fittings attached to the wire rope end eyes; b) type B: fixed length restraint sling extensions, to be used in conjunction with a type A cable; extensions are usually terminated at both ends by eyes, without additional fittings, and can be attached through hooks or shackles. The cables specified in this document are intended exclusively for restraint purposes on board aircraft, and not for use as lifting slings.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20291-1-2021 PDF

ISO 20291-1-2021 PDF

$96.50 $193.00