ISO 1996-1-2016 PDF

ISO 1996-1-2016 PDF

Acoustics - Description, measurement and assessment of environmental noise - Part 1: Basic quantities and assessment procedures

$60.00 $120.00 -50%
Product Code: ISO 1996-1
Stock In Stock
Edition: 3RD
Published: 03/01/2016
Number of Pages: 54
File Size: 1 file, 859 Bytes

Available Options

Product Description

Acoustique — Description, mesurage et évaluation du bruit de l'environnement — Partie 1: Grandeurs fondamentales et méthodes d'évaluation

Introduction: To be of practical use, any method of description, measurement, and assessment of environmental noise is intended to be related in some way to what is known about human response to noise. Many adverse consequences of environmental noise increase with increasing noise, but the precise dose-response relationships involved continue to be the subject of scientific debate. In addition, it is important that all methods used be practicable within the social, economic, and political climate in which they are used. For these reasons, there is a very large range of different methods in use around the world for different types of noise, and this creates considerable difficulties for international comparison and understanding. The broad aim of the ISO 1996 series is to contribute to the international harmonization of methods of description, measurement, and assessment of environmental noise from all sources. The methods and procedures described in this part of ISO 1996 are intended to be applicable to noise from various sources, individually or in combination, which contribute to the total exposure at a site. At the stage of technology at the time of publication of this part of ISO 1996, the evaluation of long- term noise annoyance seems to be best met by adopting the adjusted A-weighted equivalent continuous sound pressure level, which is termed a “rating level”. The aim of the ISO 1996 series is to provide authorities with material for the description and assessment of noise in communi

Scope: This part of ISO 1996 defines the basic quantities to be used for the description of noise in community environments and describes basic assessment procedures. It also specifies methods to assess environmental noise and gives guidance on predicting the potential annoyance response of a community to long-term exposure from various types of environmental noises. The sound sources can be separate or in various combinations. Application of the method to predict annoyance response is limited to areas where people reside and to related long-term land uses. Community response to noise can vary differently among sound sources that are observed to have the same acoustic levels. This part of ISO 1996 describes adjustments for sounds that have different characteristics. The term “rating level” is used to describe physical sound predictions or measurements to which one or more adjustments have been added. On the basis of these rating levels, the long-term community response can be estimated. The sounds are assessed either singly or in combination, allowing for consideration, when deemed necessary by responsible authorities, of the special characteristics of their impulsiveness, tonality, and low-frequency content, and for the different characteristics of road-traffic noise, other forms of transportation noise (such as aircraft noise), and industrial noise. This part of ISO 1996 does not specify limits for environmental noise. NOTE 1 In acoustics, several different physical measures describing sound can have their level expressed in decibels (e.g. sound pressure, maximum sound pressure, and equivalent continuous sound pressure). The levels corresponding to these physical measures normally will differ for the same sound. This often leads to confusion. Therefore, it is necessary to specify the underlying physical quantity (e.g. sound pressure level, maximum sound pressure level, and equivalent continuous sound pressure level). NOTE 2 In this part of ISO 1996, quantities are expressed as levels in decibels. However, some countries validly express the underlying physical quantity, such as maximum sound pressure, in pascal or sound exposure in pascal-squared seconds. NOTE 3 ISO 1

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 1996-1-2016 PDF

ISO 1996-1-2016 PDF

$60.00 $120.00