ISO 20155-2017 PDF

ISO 20155-2017 PDF

Ships and marine technology - Test method of flow induced in-pipe noise source characteristics for a shipused pump

$96.50 $193.00 -50%
Product Code: ISO 20155
Stock In Stock
Edition: 1ST
Published: 08/2017
Number of Pages: 32
File Size: 1 file, 1 Byte

Available Options

Product Description

Ships and marine technology - Test method of flow induced in-pipe noise source characteristics for a shipused pump

Introduction: In hydraulic fluid power systems of ships, power is transmitted through a liquid under pressure. Pumps are components that convert rotary mechanical power into hydraulic fluid power. During the process of converting mechanical power into hydraulic power, flow and pressure fluctuations and structure-borne vibrations are generated. These fluid-borne and structure-borne vibrations, which are generated primarily by the unsteady flow produced by the pump, are transmitted through the connected piping system. The fluid-borne vibration generated by a pump is called pressure ripple or flow induced noise. For pumps used for coolant and drainage in ships, flow induced noise can be transmitted along the piping and radiated into the surrounding water area through a pipe mouth outboard the ship, which produces noise pollution and disturbs the environment including marine mammals. The level of flow induced noise for a pump depends upon not only the characteristics of the pump itself, but also the circuit in which the pump is installed. Thus, the determination of flow induced noise by a pump is complicated by the interaction between the pump and the circuit. The directly measured data using hydrophones inserted in pipe reaches connecting the pump cannot reflect noise source characteristics of the pump. The method adopted to measure the flow induced noise of a pump should be such as to eliminate the interaction. ISO 10767-1 and ISO 10767-2 provide the test methods for the positive displacemen

Scope: This document specifies a test method for determining flow induced in-pipe noise source characteristics of a ship-used pump as a two-port sound source in laboratory conditions by measuring acoustic pressures in the pipe reaches of inlet and outlet. The test method is applicable to all types of centrifugal pumps with a diameter over 50 mm operating under steady conditions. The suitable frequency range of the test method is about 10 Hz to 1 000 Hz, and the upper frequency is dependent on the inner diameter of the pipe, in which the plane acoustic wave propagates.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20155-2017 PDF

ISO 20155-2017 PDF

$96.50 $193.00