ISO 20267-2017 PDF

ISO 20267-2017 PDF

Thermal spraying - Determination of interfacial toughness of ceramic coatings by indentation

$48.00 $96.00 -50%
Product Code: ISO 20267
Stock In Stock
Edition: 1ST
Published: 05/2017
Number of Pages: 18
File Size: 1 file, 577 Bytes

Available Options

Product Description

Thermal spraying - Determination of interfacial toughness of ceramic coatings by indentation

Introduction: The interfacial toughness of thermal spray ceramic coatings is required for two reasons: a) to understand quantitatively degradation of adhesion in service; b) for life assessment of the coated components. Adhesion strength of thermal spray coatings is usually measured in accordance with the tensile method specified by ISO 14916. However, there is a technical limitation in the application of ISO 14916. It requires preparation of a tensile adhesion test specimen using glue and, as such, coatings with higher adhesion strength than glue cannot be quantitatively evaluated. By virtue of its simplicity and practicality, an indentation method is a promising method to evaluate the adhesion of such coatings. In this method, a Vickers hardness tester is used. An interfacial toughness value is evaluated by measuring a length of the crack formed after pushing the indenter on the coating interface. The application of the method specified in this document can reduce uncertainty over the adhesion strength evaluation of coatings and makes it possible to evaluate the adhesion strength in a simpler way. The results can be expressed either as a stress intensity factor, in MN∙m-3/2, or as a fracture surface energy, in J∙m-2. “Interfacial toughness” can have several meanings. a) Interfacial fracture toughness, KIc, in MN∙m-3/2, is a material constant that shows how easily the coating may be peeled away from a substrate. b) Energy release rate (or work done to fracture), G, is an alternative expre

Scope: This document specifies a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method. The interfacial toughness is calculated from the mean length of cracks emanating from the corners of the impression induced by a Vickers hardness tester, and it is intended for use with ceramic coatings with a single layer or multilayers. The test procedures proposed in this document are intended for use in an ambient environment. This document is recommended for thermal spray ceramic coatings such as thermal barrier coatings, wear resistant coatings and electrical insulating coatings.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 20267-2017 PDF

ISO 20267-2017 PDF

$48.00 $96.00