ISO TR 4813-2021 PDF

ISO TR 4813-2021 PDF

Hydraulic fluid power-Background, impact and use of ISO 11171:2020 on particle count and filter test data

$96.50 $193.00 -50%
Product Code: ISO TR 4813
Stock In Stock
Edition: 1ST
Published: 02/2021
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Hydraulic fluid power — Background, impact and use of ISO 11171:2020 on particle count and filter test data

Introduction: The 2020 revision of ISO 11171 was initiated due to depletion of supplies of the National Institute of Standards and Technology (NIST) Standard Reference Material® (SRM) 2806b, which is required for primary calibration of liquid automatic particle counters (APC) using ISO 11171:2016. The 2016 edition of ISO 11171 also provides an option for reporting particle size in units of either µm(c) or µm(b), which has resulted in confusion among users of particle count data. µm(b) sizes are about 10 % larger than the corresponding µm(c) sizes. Thus, µm(b) concentrations can be as much as 8 times (3 ISO Codes) lower, and µm(b) filter Beta Ratios can be an order of magnitude lower than the same numerical value reported in µm(c). This is problematic when attempting to conform with fluid cleanliness and filter performance specifications. ISO 11171:2020 addresses these issues by specifying the historically consistent, traceable µm(c) as the sole acceptable means of reporting particle size. Unlike the 2016 edition, ISO 11171:2020 is not dependent upon a specific batch of SRM 2806, as NIST henceforth certifies the material as a consensus standard to minimize the potential for shifts in particle size with future batches. Additional refinements to ISO 11171 facilitate calibration at smaller and larger particle sizes. © ISO 2021 – All rights reserved

Scope: This document provides the background for ISO 11171:2020 and the use of µm(c) as the sole means of reporting particle size for APC particle count data. It also summarizes results of the international inter- laboratory study (ILS) of its reproducibility using SRM 2806d candidate material and suspensions of Reference Material (RM) 8632a. The ILS results provided the basis for certification of SRM 2806d used for primary calibration of APC. Their implications with respect to particle counting and filter testing are discussed in this document.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TR 4813-2021 PDF

ISO TR 4813-2021 PDF

$96.50 $193.00